Honda HR-V: VSA System - Diagnostics
READ NEXT:
NOTE: Before you troubleshoot, review the general troubleshooting
information.
1. Problem verification:
Turn the vehicle to the ON mode.
Clear the DTCs with the HDS.
Turn the vehicle to the OFF
NOTE: Before you troubleshoot, review the general troubleshooting
information.
1. Problem verification:
Turn the vehicle to the ON mode.
Clear the DTC with the HDS.
Turn the vehicle to the OFF (
SEE MORE:
Removal & Installation
1. Rear Seat - Remove
Lift up both rear seat cushions
Pull the rear seat belt buckles (A) out through each elastic
straps (B)
Remove the clips.
Fig. 6: Fold Down Rear Seat Back Mounting Bolts Torque Specifications
Fold down both rear seat-back
Pull up the both c
If you suspect there is an immobilizer system problem, check the status log
in the HDS.
1. Connect the HDS to the data link connector (DLC).
2. Turn the vehicle to the ON mode.
3. On the HDS screen, at SYSTEM SELECTION MENU, enter IMMOBI, then select
IMMOBILIZER SETUP,
select SYSTEM CHECK, NUMBER