Honda HR-V Owners & Service Manuals

Honda HR-V: DTC 1303 GPS Receiver Error 2

NOTE:

  • Check the vehicle 12 volt battery condition first.
  • This navigation DTC sets when there is an internal GPS receiver problem (reboot error).
  • Aftermarket metallic window tint or electronic devices located near the audio-navigation unit or GPS antenna can potentially interfere with the operation of the system.
  • Before you troubleshoot, make sure to follow the General Troubleshooting Information.
  • Check any official Honda service website for more service information about the navigation system.

1. Problem verification:

  1. Clear the hard error codes.
  2. Turn the vehicle to the OFF (LOCK) mode then the ON mode, and wait at least 30 seconds.
  3. Check for hard error codes.

Is DTC 1303 indicated?

YES

Replace the audio-navigation unit.

NO

Intermittent failure, the system is OK at this time.

DTC 1303 GPS RECEIVER ERROR 2

NOTE:

  • Check the vehicle 12 volt battery condition first.
  • This audio DTC sets when there is an internal GPS receiver problem (reboot error).
  • Aftermarket metallic window tint or electronic devices located near the audio unit or GPS antenna can potentially interfere with the operation of the system.
  • Before you troubleshoot, make sure to follow the General Troubleshooting Information.

1. Problem verification:

  1. Clear the hard error codes.
  2. Turn the vehicle to the OFF (LOCK) mode then the ON mode, and wait at least 30 seconds.
  3. Check for hard error codes.

Is DTC 1303 indicated?

YES

Replace the audio unit - Refer to: Audio Unit Removal and Installation (Display Audio Type (7-inch Screen), or Audio Unit Removal and Installation (Color Audio Type (5-inch Screen).

NO

Intermittent failure, the system is OK at this time.

    READ NEXT:

     DTC 1304 Gyro Error 1

    NOTE: Check the vehicle 12 volt battery condition first. This navigation DTC sets when there is an internal gyro problem. Before you troubleshoot, make sure to follow the General Troubleshooting

     DTC 1306 Vehicle Speed Pulse

    NOTE: Check the vehicle 12 volt battery condition first. This navigation DTC sets when there is a problem with the VSP circuit. Check for aftermarket accessories that may interfere with the naviga

     DTC 1402 Audio Error 2

    NOTE: Check the vehicle 12 volt battery condition first. This audio DTC sets when there is a problem with the built-in CD player, or an unplayable disc is inserted. Check that the fan screen on

    SEE MORE:

     DTC Troubleshooting, Testing

    DTC TROUBLESHOOTING VSA SYSTEM DTC TROUBLESHOOTING INDEX TESTING VSA MODULATOR-CONTROL UNIT UPDATE Special Tools Required MVCI unit with the latest control module (CM) update software installed Procedure NOTE: High temperature in the engine compartment might cause the VSA modulator-control uni

     Testing

    BRAKE PEDAL POSITION SWITCH TEST Test 1. Brake Pedal Position Switch - Test Disconnect the connector (A). Check for continuity between the terminals in each switch position according to the table. If the test resultss are not as specified, adjust the brake pedal position switch (B), then rec

    © 2019-2026 Copyright www.hohrv2.com