Removal & Installation
SRS components are located in this area. Review the SRS component locations -
Refer to: SRS Component
Location Index (KA/KC), or SRS Component Location Index (KA/KC) and th
Removal & Installation
NOTE:
When working on electronic components, make sure the work area is clean
and dust free.
Make sure your hands are clean and free of oils and grease.
Eject the CD b
Hard-to start condition - Possible cause pattern chart from diagnostic
interview
FUEL CAP WARNING MESSAGE STAYS ON (MIL WORKS OK, NO DTCS SET) (KA/KC)
Diagnostic procedure
Do the troubleshooting procedure for DTC P0455 and P0456, refer to
appropriate DTC. Fuel and Emissions
Systems DTC Troublesh
Removal & Installation
A-Pillar Trim
1. A-Pillar Trim - Remove
Remove the front door opening seal (A) as needed
Remove the A-pillar trim (B).
2. All Removed Parts - Install
Install the parts reverse order of removal.
B-Pillar Upper/Lower Trim
3. Front Door Sill Trim - Remove - Refer to: