Honda HR-V: Registration
- Immobilizer Key Registration
- Keyless Access Control Unit Connector For Inputs And Outputs
- Keyless Access System Registration
READ NEXT:
Immobilizer Key Registration
Procedure
1. Immobilizer Key - Register
NOTE:
The HDS is required for registration of the immobilizer keys.
Programming the immobilizer also programs the keyless transmitter.
Check for aftermarket
Keyless Access Control Unit Connector For Inputs And Outputs
*1: M/T
*2: CVT
KEYLESS ACCESS SYSTEM ELECTRONIC WIRING DIAGRAM
Power Door Locks
Keyless Access System Registration
Procedure
NOTE: If you replace the keyless access control unit or steering lock, the
vehicle is not turned to the ON mode.
Follow the registration procedure of the corresponding unit.
1. Keyless Acc
SEE MORE:
Combination Light Switch Removal, Installation, and Test
Removal & Installation
NOTE : SRS components are located in this area. Review the SRS component
locations - Refer to: SRS Component Location Index (KA/KC), or SRS Component
Location Index (KA/KC) and the precautions
and procedures before doing repairs or service.
1. Column Cover - Remove
2. Co
DTC Troubleshooting 25-121, 26-121, 28-121: Sensor (Inside of
Modulator-Control Unit) Output Signal Malfunction
NOTE:
Before you troubleshoot, review the general troubleshooting information.
The yaw rate-acceleration sensor is built into the VSA modulator-control
unit.
Before troubleshooting, check the VSA modulator-control unit for proper
mounting. Improper mounting
of the VSA modulator-control unit
© 2019-2026 Copyright www.hohrv2.com
