Honda HR-V: Security System Keyless Entry System - Testing & Troubleshooting
Honda HR-V (2015-2021) Service Manual / Accessories & Equipment / Security System Keyless Entry System - Testing & Troubleshooting
- Inspection/Adjustment
- Description
- Testing
- General Information
- Symptom Troubleshooting
- Troubleshooting
- Registration
READ NEXT:
Inspection/Adjustment
IMMOBILIZER SYSTEM CHECK
1. Connect the HDS to the data link connector (DLC).
2. Turn the vehicle to the ON mode.
3. Monitor the SYSTEM CHECK in IMMOBILIZER INFO with the HDS.NOTE: If the HDS
does no
Immobilizer System Description - Overview
An immobilizer system adds a second electronic layer of security to the
vehicle. If the key matches
mechanically, but the electronic check does not match, the engine control
computer suspends fuel d
SEE MORE:
Rear Spring Removal and Installation (AWD)
Removal
1. Vehicle - Lift
2. Rear Wheels - Remove
3. Wheel Speed Sensor Wire Bracket - Remove (Left Side)
4. Brake Hose - Remove (Right Side)
5. Muffler - Remove
6. Propeller Shaft - Remove
7. Breather Hose - Disconnect
8. Rear Differential - Remove
Position a floor jack under rear differential
DTC Troubleshooting 58-11: Brake Diag Circuit OFF Failure
NOTE: Before you troubleshoot, review the general troubleshooting
information.
1. Problem verification:
Turn the vehicle to the ON mode.
Clear the DTC with the HDS.
Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.
Do the BRAKE LIGHT RELAY function test with the HDS.
Check for DT
© 2019-2026 Copyright www.hohrv2.com
