Honda HR-V: AWD System - Diagnostics
Honda HR-V (2015-2021) Service Manual / Driveline & Axles / AWD System - Diagnostics
- DTC C1840-12 (47-01): Differential Fluid Pressure Sensor Circuit High Voltage (AWD)
- DTC C1840-14 (47-02): Differential Fluid Pressure Sensor Circuit Low Voltage (AWD)
- DTC C1841-11 (42-02): Differential Fluid Temperature Sensor Circuit Low Voltage (AWD)
- DTC C1841-13 (42-01): Differential Fluid Temperature Sensor Circuit High Voltage (AWD)
- DTC C1841-27 (43-01): Differential Fluid Temperature Sensor Circuit Range/Performance Problem (AWD)
- DTC C1850-12 (44-12): Fail Safe Relay Stuck ON (AWD)
- DTC C1850-14 (44-50): Fail Safe Relay Stuck OFF (AWD)
- DTC C1851-18 (63-01): Motor Circuit Low Current (AWD)
- DTC C1852-19 (62-04): Solenoid Valve Circuit High Current (AWD)
- DTC C1858-72 (71-02): Differential Fluid Pressure Deviation Low (AWD)
- DTC C1860-98 (76-01): Differential Fluid Overheated (AWD)
- DTC C1861-9A (76-02): Vehicle Spin Detected (AWD)
- DTC C1873-00 (16-04): Steering Angle Sensor Malfunction (AWD)
- DTC U3000-49 (78-XX): Control Module Internal Control Module Malfunction (AWD)
READ NEXT:
DTC C1840-12 (47-01): Differential Fluid Pressure Sensor Circuit
High Voltage
(AWD)
NOTE: Before you troubleshoot, review the General Troubleshooting Information
for the AWD with
intelligent control system.
1. Determine possible failure area (electrical circuit problem, hydraulic
DTC C1840-14 (47-02): Differential Fluid Pressure Sensor Circuit Low
Voltage
(AWD)
NOTE: Before you troubleshoot, review the General Troubleshooting Information
for the AWD with
intelligent control system.
1. Problem verification:
Start the engine.
Check the parameter(s) below
DTC C1841-11 (42-02): Differential Fluid Temperature Sensor Circuit
Low Voltage (AWD)
NOTE: Before you troubleshoot, review the General Troubleshooting Information
for the AWD with
intelligent control system.
1. Problem verification:
Turn the vehicle to the ON mode.
Check the para
SEE MORE:
DTC Troubleshooting B0082-12: Short to Power in the Selectable
Energy Absorption Device of the Front Passenger's Seat Belt Tensioner
NOTE:
Before doing this troubleshooting procedure, find out if the vehicle was
in a collision. If so, verify
that all the required components were replaced with new components of the
correct part number,
and that they were properly installed.
Before doing this troubleshooting procedure, rev
DTC U1280 (Gauge Control Module) Communication Bus Line Error (BUS-OFF)
DTC (Gauge Control Module)
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the
instructions in B-CAN System Diagnosis Test Mode A - Refer to: Body
Electrical Troubleshooting - B-CAN System Diagnosis Test Mode A - Initial
Communication and DTC Checks.
If you have any loss
© 2019-2026 Copyright www.hohrv2.com
