Honda HR-V: Driveline & Axles
Honda HR-V (2015-2021) Service Manual / Driveline & Axles
- AWD System - Diagnostics
- DTC C1840-12 (47-01): Differential Fluid Pressure Sensor Circuit High Voltage (AWD)
- DTC C1840-14 (47-02): Differential Fluid Pressure Sensor Circuit Low Voltage (AWD)
- DTC C1841-11 (42-02): Differential Fluid Temperature Sensor Circuit Low Voltage (AWD)
- DTC C1841-13 (42-01): Differential Fluid Temperature Sensor Circuit High Voltage (AWD)
- DTC C1841-27 (43-01): Differential Fluid Temperature Sensor Circuit Range/Performance Problem (AWD)
- DTC C1850-12 (44-12): Fail Safe Relay Stuck ON (AWD)
- DTC C1850-14 (44-50): Fail Safe Relay Stuck OFF (AWD)
- DTC C1851-18 (63-01): Motor Circuit Low Current (AWD)
- DTC C1852-19 (62-04): Solenoid Valve Circuit High Current (AWD)
- DTC C1858-72 (71-02): Differential Fluid Pressure Deviation Low (AWD)
- DTC C1860-98 (76-01): Differential Fluid Overheated (AWD)
- DTC C1861-9A (76-02): Vehicle Spin Detected (AWD)
- DTC C1873-00 (16-04): Steering Angle Sensor Malfunction (AWD)
- DTC U3000-49 (78-XX): Control Module Internal Control Module Malfunction (AWD)
- Real Time AWD Control Unit - Diagnostics
- DTC Troubleshooting C1851-19 (63-02), C1851-1E (63-03), C1851-1E (63-04): Motor Circuit Low Current, Motor Circuit High Current (AWD)
- DTC Troubleshooting C1852-18 (62-01): Solenoid Valve Circuit Low Current (AWD)
- Differential - Testing & Troubleshooting
- Removal Installation
- Component Location Index, Description
- DTC Troubleshooting
- Symptom Troubleshooting
- Inputs and Outputs
- How to Information
- Driveshafts - Service Information
- Front Driveshaft Removal and Installation
- Intermediate Shaft Removal and Installation
- Rear Driveshaft Removal and Installation (AWD)
- Driveshafts - Overhaul, Inspection & Adjustment
READ NEXT:
DTC C1840-12 (47-01): Differential Fluid Pressure Sensor Circuit
High Voltage
(AWD)
NOTE: Before you troubleshoot, review the General Troubleshooting Information
for the AWD with
intelligent control system.
1. Determine possible failure area (electrical circuit problem, hydraulic
DTC C1840-14 (47-02): Differential Fluid Pressure Sensor Circuit Low
Voltage
(AWD)
NOTE: Before you troubleshoot, review the General Troubleshooting Information
for the AWD with
intelligent control system.
1. Problem verification:
Start the engine.
Check the parameter(s) below
SEE MORE:
Front Stabilizer Bar Removal and Installation (AWD)
Removal
1. Vehicle - Lift
2. Front Wheels - Remove
3. Steering Column Tilt and Telescopic Position - Set
Set the steering column to the center tilt position, and to the center
telescopic position.
4. Steering Wheel - Hold
Center the steering wheel spoke angle
Install a commercially availabl
Clutch Pedal and Clutch Pedal Position Switch Adjustment (M/T)
Adjustment
NOTE:
For a clutch interlock operation problem, check clutch pedal position
switch A.
If there is no clearance between the master cylinder piston and the push
rod, the release bearing will be held against the diaphragm spring, which
can result in clutch slippage or other clutch
© 2019-2026 Copyright www.hohrv2.com
