Honda HR-V: DTC U3000-49 (78-XX): Control Module Internal Control Module Malfunction (AWD)
NOTE: Before you troubleshoot, review the General Troubleshooting Information for the AWD with intelligent control system.
.png)
1. Problem verification:
- Turn the vehicle to the ON mode.
- Clear the DTC with the HDS.
- Start the engine.
- Check for DTCs with the HDS.
.png)
Is DTC U3000-49 indicated?
YES
The failure is duplicated. Update the AWD control unit if it does not have the latest software, or substitute a known-good AWD control unit, and recheck. If the symptom/indication goes away with the updated AWD control unit, troubleshooting is complete. If the symptom/indication goes away with a known-good AWD control unit, replace the original AWD control unit.
NO
Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the Freeze data/on-board snapshot.
DTC U3000-51 (91-01): CONTROL MODULE PROGRAMMING ERROR (AWD)
NOTE: Before you troubleshoot, review the General Troubleshooting Information for the AWD with intelligent control system.
.png)
1. Problem verification:
- Turn the vehicle to the ON mode.
- Update the AWD control unit. if it does not have the latest software.
- Clear the DTC with the HDS.
- Start the engine.
- Clear the DTC with the HDS.
.png)
Is DTC U3000-51 indicated?
YES
The failure is duplicated. Substitute a known-good AWD control unit, and recheck. If the symptom/indication goes away with a known-good AWD control unit, replace the original AWD control unit.
NO
Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the Freeze data/on-board snapshot.
READ NEXT:
DTC Troubleshooting C1851-19 (63-02), C1851-1E (63-03), C1851-1E (63-04):
Motor Circuit Low Current, Motor Circuit High Current (AWD)
NOTE: Before you troubleshoot, review the General Troubleshooting
Information.
1. Problem verification (with engine idling):
Turn the vehicle to the ON mode.
Clear the DTC with the HDS.
Start th
DTC Troubleshooting C1852-18 (62-01): Solenoid Valve Circuit Low
Current
(AWD)
NOTE: Before you troubleshoot, review the General Troubleshooting
Information.
1. Problem verification (with engine idling):
Turn the vehicle to the ON mode.
Clear the DTC with the HDS.
Start th
SEE MORE:
Handsfreelink System Self-Diagnostic Function
NOTE:
Check the vehicle 12 volt battery condition first.
The self-diagnostic function can only be initiated while the HFL is in
its idle state.
1. Turn the vehicle to the ACCESSORY mode
2. Press and hold the HANG-UP/BACK button (A) for more than 5 seconds.
3. When the HFL system enters the se
Steering & Suspension
MANUAL STEERING GEAR TROUBLE SHOOTING
NOTE: This is GENERAL information. This article is not intended to be
specific to any
unique situation or individual vehicle configuration. The purpose of this
Trouble Shooting information is to provide a list of common causes to problem
symptoms. For model-sp
