Honda HR-V: Disassembly/Reassembly
Honda HR-V (2015-2021) Service Manual / Engine / Fuel and Emissions - Testing & Troubleshooting / Disassembly/Reassembly
- Fuel Pressure Relieving
- Fuel Tank Unit Disassembly and Reassembly (2WD)
- Fuel Tank Unit Disassembly and Reassembly (AWD)
READ NEXT:
Fuel Pressure Relieving
Procedure
NOTE:
Before disconnecting fuel lines or hoses, relieve pressure from the
system by disabling the fuel pump and
disconnecting the fuel line/quick connect fitting in the engine compartme
Fuel Tank Unit Disassembly and Reassembly (2WD)
Disassembly/Reassembly
The fuel filter should be replaced whenever the fuel pressure drops below the
specified value, after making sure
that the fuel pump and the fuel pressure regulator are OK.
NOTE
Fuel Tank Unit Disassembly and Reassembly (AWD)
Disassembly/Reassembly
The fuel filter should be replaced whenever the fuel pressure drops below the
specified value, after making sure
that the fuel pump and the fuel pressure regulator are OK.
Fuel
SEE MORE:
Gauges - Service Information
REMOVAL & INSTALLATION
ECON SWITCH REMOVAL AND INSTALLATION
Removal and Installation
1. Driver's Dashboard Lower Cover - Remove
2. ECON Switch - Remove
3. All Removed Parts - Install
Install the parts in the reverse order of removal.
GAUGE CONTROL MODULE REMOVAL AND INSTALLATION
Removal and
Door Key Cylinder Switch Test
Test
1. Driver's Door Panel - Remove
2. Driver's Door Key Cylinder Switch - Test
Disconnect the connector (A).
Check for continuity between the terminals in each
switch position according to the table.
If the continuity is not as specified, the door key
cylinder switch is faulty; replace the
© 2019-2026 Copyright www.hohrv2.com
