Honda HR-V: Driveshafts - Overhaul, Inspection & Adjustment
READ NEXT:
DRIVESHAFT INSPECTION
Inspection
1. Driveshaft - Inspect
Check the inboard boot (A) and the outboard boot (B) on the driveshaft
(C) for
cracks, damage, leaking grease, and loose boot bands (D).
Special Tools Required
CV Boot Clamp Pliers 30500, commercially
available
Bearing Puller, commercially available
Slide Hammer 5/8"-18 UNF, commercially available
Threaded Adapter, 26 x 1.5 mm 07XAC
SEE MORE:
DTC (Power Control Unit)
NOTE: If you are troubleshooting multiple DTCs, be sure to follow the
instructions in B-CAN System
Diagnosis Test Mode A - Refer to: Body Electrical Troubleshooting - B-CAN System
Diagnosis Test Mode
A - Initial Communication and DTC Checks.
1. Problem verification:
Sel
Removal & Installation
1. Rear Seat Armrest - Remove
Fold down the right rear seat-back
Remove the rear seat armrest trim (A).
Remove the bolt.
Remove the rear seat armrest (A)
If necessary, remove the bushings (B).
2. All Removed Parts - Install
Install the parts in the reverse