Honda HR-V: Disassembly and Reassembly
Honda HR-V (2015-2021) Service Manual / Driveline & Axles / Driveshafts - Overhaul, Inspection & Adjustment / Disassembly and Reassembly
- Front Driveshaft Disassembly and Reassembly
- Intermediate Shaft Disassembly and Reassembly
- Rear Driveshaft Disassembly and Reassembly (AWD)
READ NEXT:
Front Driveshaft Disassembly and Reassembly
Special Tools Required
CV Boot Clamp Pliers 30500, commercially
available
Bearing Puller, commercially available
Slide Hammer 5/8"-18 UNF, commercially available
Threaded Adapter, 26 x 1.5 mm 07XAC
Intermediate Shaft Disassembly and Reassembly
Special Tools Required
Half Shaft Base 07NAF-SR30101
Oil Seal Driver, 44.5 mm 07947-SB00100
Driver Handle, 15 x 135L 07749-0010000
Bearing Driver Attachment, 52 x 55 mm
07746-0010400
Oil Seal Driv
Rear Driveshaft Disassembly and Reassembly (AWD)
Special Tools Required
Slide Hammer 5/8"-18 UNF, commercially available
Threaded Adapter, 22 x 1.5 mm 07XAC-001010A
Boot Band Clamp Tool Kent-Moore J-35910 or
equivalent, commercially available
CV
SEE MORE:
DTC Troubleshooting B0082-11: Short to Ground in the Selectable Energy
Absorption Device of the Front Passenger's Seat Belt Tensioner
NOTE:
Before doing this troubleshooting procedure, find out if the vehicle was
in a collision. If so, verify
that all the required components were replaced with new components of the
correct part number,
and that they were properly installed.
Before doing this troubleshooting procedure, rev
Valve Seat Reconditioning
Reconditioning
1. Valve, Valve Seal, and Valve Spring Seat - Remove
2. Valve Seat - Reconditioning
Inspect valve stem-to-guide clearance. If the valve guides are worn,
replace them before cutting the valve seats.
Renew the valve seats in the cylinder head using a valve seat cutter.
Carefully c
© 2019-2026 Copyright www.hohrv2.com
