Honda HR-V Owners & Service Manuals

Honda HR-V: DTC 1101 Media Bus Send Error

NOTE:

  • Check the vehicle 12 volt battery condition first.
  • This audio DTC sets when there is an internal error in BUS sending.
  • Before you troubleshoot, make sure to follow the General Troubleshooting Information.

1. Problem verification:

  1. Clear the hard error codes.
  2. Turn the vehicle to the OFF (LOCK) mode then the ON mode.
  3. Wait for at least 1 minutes.
  4. Check for hard error codes.

Is DTC 1101 indicated?

YES

Replace the audio unit - Refer to: Audio Unit Removal and Installation (Display Audio Type (7-inch Screen), or Audio Unit Removal and Installation (Color Audio Type (5-inch Screen).

NO

Intermittent failure, the system is OK at this time.

DTC 1101 MEDIA BUS SEND ERROR

NOTE:

  • Check the vehicle 12 volt battery condition first.
  • This navigation DTC sets when there is an internal error in BUS sending.
  • Before you troubleshoot, make sure to follow the General Troubleshooting Information.
  • Check any official Honda service website for more service information about the navigation system.

1. Problem verification:

  1. Clear the hard error codes.
  2. Turn the vehicle to the OFF (LOCK) mode then the ON mode, and wait at least 1 minute.
  3. Check for hard error codes.

Is DTC 1101 indicated?

YES

Replace the audio-navigation unit.

NO

Intermittent failure, the system is OK at this time.

    READ NEXT:

     DTC 1102 USB Diag

    NOTE: Check the vehicle 12 volt battery condition first. This navigation DTC sets when a problem is detected with the USB device that is connected to the USB port. Before you troubleshoot, make

     DTC 1301 GPS Antenna Error

    NOTE: Check the vehicle 12 volt battery condition first. This audio DTC sets when there is poor connectors or loose terminals at the GPS antenna connector or an open in GPS antenna lead. Before

     DTC 1302 GPS Receiver Error 1

    NOTE: Check the vehicle 12 volt battery condition first. This audio DTC sets when there is an internal GPS receiver problem (freeze error). Before you troubleshoot, make sure to follow the Gener

    SEE MORE:

     Resetting The Power Window Control Unit

    Procedure Reset the power window control unit after doing any of the following actions: Driver's power window regulator replacement, removal, or installation. Driver's power window motor replacement, removal, or installation. Glass run channel replacement, removal, or installation. Door glass r

     Audio Unit Button Illumination Does Not Work (Without Navigation, Display Audio Type (7-inch Screen) )

    NOTE: Check the vehicle 12 volt battery condition first. Check for B-CAN DTCs and resolve them before troubleshooting. Check the connectors for poor connections or loose terminals. 1. Problem verification: Turn the vehicle to the ON mode Turn the combination lighting switch to the parking li

    © 2019-2026 Copyright www.hohrv2.com