Honda HR-V: DTC U0073 F-CAN Communication Bus Line Error
.png)
DTC (Power Control Unit)
NOTE: If you are troubleshooting multiple DTCs, be sure to follow the
instructions in B-CAN System
Diagnosis Test Mode A - Refer to: Body Electrical Troubleshooting - B-CAN System
Diagnosis Test Mode
A - Initial Communication and DTC Checks.
1. Problem verification:
- Clear the DTCs with the HDS.
Clear DTCs
- Turn the vehicle to the OFF (LOCK) mode and then the ON mode.
- Wait for at least 6 seconds.
- Check for DTCs with the HDS.
.png)
Is DTC U0073 indicated?
YES
Go to DLC Circuit Troubleshooting.
NO
Intermittent failure, the system is OK at this time.
READ NEXT:
NOTE:
Refer to the DTC code shown on the display, and then inspect the
connectors and terminals based on the
instructions in the table below.
The DTC may be stored due to the grounding failure o
DTC (Power Control Unit)
NOTE: If you are troubleshooting multiple DTCs, be sure to follow the
instructions in B-CAN System
Diagnosis Test Mode A - Refer to: Body Electrical Troubleshooting - B-CAN
NOTE:
Refer to the DTC code shown on the display, and then inspect the
connectors and terminals based on the instructions in the table below.
The DTC may be stored due to the grounding failure or
SEE MORE:
U.S. models only
Instead of directly measuring the pressure in each tire, the TPMS on this
vehicle
monitors and compares the rolling radius and rotational characteristics of each
wheel and tire while you are driving to determine if one or more tires are
significantly under-inflated. This will cause
NOTE:
Before you troubleshoot, review the general troubleshooting information.
While doing this troubleshooting, avoid vibration or shaking of the
vehicle.
The yaw rate-acceleration sensor is built into the VSA modulator-control
unit.
Before troubleshooting, check the VSA modulator-control