Honda HR-V Owners & Service Manuals

Honda HR-V: DTC U1280 (Keyless Access Power Control Unit)

Honda HR-V (2015-2021) Service Manual / Accessories & Equipment / Keyless Access Power Control Unit - Diagnostics / DTC U1280 (Keyless Access Power Control Unit)

Keyless Access Power Control Unit - Diagnostics

DTC (Power Control Unit)

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A - Refer to: Body Electrical Troubleshooting - B-CAN System Diagnosis Test Mode A - Initial Communication and DTC Checks.

1. Problem verification:

  1. Clear the DTCs with the HDS.

Clear DTCs

  1. Turn the vehicle to the OFF (LOCK) mode and then the ON mode.
  2. Wait for at least 6 seconds.
  3. Check for DTCs with the HDS.

Keyless Access Power Control Unit - Diagnostics

Is DTC U1280 indicated?

YES

Go to MICU DTC U1280 troubleshooting.

NO

Intermittent failure, the system is OK at this time. Check for loose or poor connections.

    READ NEXT:

     DTC U1281, U128D (Keyless Access Power Control Unit)

    NOTE: Refer to the DTC code shown on the display, and then inspect the connectors and terminals based on the instructions in the table below. The DTC may be stored due to the grounding failure or

     Security System Keyless Entry System - Testing & Troubleshooting

    DTC TROUBLESHOOTING DTC B1575 AUTO LIGHT SENSOR ERROR DTC (Automatic Lighting Control Unit) NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnos

     Integrated Control Systems

    SEE MORE:

     CVT System Description - Hydraulic Controls (CVT)

    The hydraulic control system is controlled by the transmission fluid pump, the valves, and the solenoid valves. The transmission fluid pump is driven by the engine turns. The transmission fluid pump drive sprocket is connected to the stator shaft, turns as the engine turns, and drives the transmi

     Rear Power Window Motor Test

    Test 1. Rear Door Panel - Remove 2. Rear Power Window Motor - Test Test the motor in each direction by connecting 12 volt battery power and ground to the connector (A) according to the table. When the motor stops running, disconnect 12 volt battery power immediately. If the motor does not ru

    © 2019-2025 Copyright www.hohrv2.com