Honda HR-V: DTC U1280 (Keyless Access Backup Control Unit) B-CAN Communication
Bus Line Error (BUS-OFF)
.png)
DTC (Backup Control Unit)
NOTE: If you are troubleshooting multiple DTCs, be sure to
follow the instructions in B-CAN System Diagnosis Test Mode A - Refer to: Body
Electrical Troubleshooting - B-CAN System Diagnosis Test Mode A - Initial
Communication and DTC Checks.
1. Problem verification.
- Clear the DTCs with the HDS.
Clear DTCs
- Turn the vehicle to the OFF (LOCK) mode and then the ON mode.
- Wait for at least 6 seconds.
- Check for DTCs with the HDS.
.png)
Is DTC U1280 indicated?
YES
Go to MICU DTC U1280 troubleshooting.
NO
Intermittent failure, the system is OK at this time. Check for loose or poor
connections.
READ NEXT:
NOTE: The DTC may be stored due to the grounding failure or the power source
failure at the transmitting
control unit (the grounding inspection and the power source inspection on each
control unit a
DTC (Keyless Access Control Unit)
NOTE: If you are troubleshooting multiple DTCs, be sure to follow the
instructions in B-CAN System
Diagnosis Test Mode A - Refer to: Body Electrical Troubleshooting
SEE MORE:
Removal
1. Vehicle - Lift
2. Rear Differential Fluid - Drain
3. Muffler - Remove
4. No. 2 Propeller Shaft - Disconnect
5. Connectors (Rear Differential Subharness) - Disconnect
Disconnect the connectors (A).
Remove the harness clips (A).
6. Breather Hose - Disconnect
7. Rear Differential - S
Removal and Installation
SRS components are located in this area. Review the SRS component locations -
Refer to: SRS Component
Location Index (KA/KC), or SRS Component Location Index (KA/KC) and the
precautions and
procedures before doing repairs or service.
1. 12 Volt Battery Terminal - Disconnec