Honda HR-V: ABS Indicator, Brake System Indicator (RED), VSA Indicator, And Brake System Indicator (Amber) Do Not Go OFF (VSA System)
Diagnostic procedure
1. F-Can Circuit Troubleshooting
2. VSA System Symptom Troubleshooting - VSA cannot be turned OFF or VSA System Symptom Troubleshooting - ABS indicator, brake system indicator (red), VSA indicator, and brake system indicator (amber) do not go off
ABS INDICATOR, BRAKE SYSTEM INDICATOR (RED), VSA INDICATOR, BRAKE SYSTEM INDICATOR (AMBER), OR VSA OFF INDICATOR DOES NOT COME ON AT START-UP (BULB CHECK) (VSA SYSTEM)
Diagnostic procedure
1. Gauges Self-Diagnostic Function
2. VSA Modulator-Control Unit Update If the VSA modulator-control unit was updated and the symptom is still present, Removal & Installation
HDS DOES NOT COMMUNICATE WITH THE VSA MODULATOR-CONTROL UNIT OR THE VEHICLE (VSA SYSTEM)
Diagnostic procedure
1. DLC Circuit Troubleshooting
2. Gauges Self-Diagnostic Function
VSA OFF INDICATOR DOES NOT GO OFF (VSA SYSTEM)
Diagnostic procedure
VSA Sensor Neutral Position Memorization
READ NEXT:
VSA System Symptom Troubleshooting - ABS Indicator, Brake System
Indicator (Red), VSA Indicator, And Brake System Indicator (Amber) Do Not Go
OFF
1. DTC check:
Turn the vehicle to the ON mode.
Check for DTCs with the HDS.
Are there DTCs indicated?
YES
Do the DTC troubleshooting.
NO
Go to step 2.
2. Gauge control module operation check.
D
VSA System Symptom Troubleshooting - VSA Cannot Be Turned OFF
VSA cannot be turned OFF
NOTE: If the low tire pressure indicator turns ON, the VSA cannot be turned
OFF. Check the tire pressure first.
1. VSA OFF switch check:
Turn the vehicle to the OFF (LOCK)
Inputs and Outputs
VSA MODULATOR-CONTROL UNIT CONNECTOR FOR INPUTS AND OUTPUTS
VSA Modulator-Control Unit Inputs and Outputs for 21P Connector
*1: M/T
VSA SENSOR NEUTRAL POSITION MEMORIZATION
Procedure
1. HDS - Connec
SEE MORE:
Rear Damper Removal, Installation, and Inspection
Exploded View
1. Rear Damper - Exploded View
Exploded View
Removal
NOTE: Unless otherwise indicated, illustrations used in the procedure are for
2WD model.
1. Vehicle - Lift
2. Rear Wheel - Remove
3. Damper Lower Side - Remove
Position a floor jack under lower spring seat (A) of the axle beam.
Sight Support - Service Information
REMOVAL & INSTALLATION
LANE WATCH CAMERA REMOVAL AND INSTALLATION
Removal and Installation
1. Power Mirror - Remove
2. Mirror Holder - Remove
3. Mirror Housing Cover - Remove
4. Mirror Housing Under Cover - Remove. MIRROR HOUSING REMOVAL AND
INSTALLATION
5. Lane Watch Camera - Remove
Disconn
