Honda HR-V: How to Refuel
1. Stop your vehicle with the service station pump on the left side of the vehicle in the rear.
2. Turn off the engine.
3. Pull on the fuel fill door release handle under the lower left corner of the dashboard.
- The fuel fill door opens.
.png)
4. Remove the fuel fill cap slowly. If you hear a release of air, wait until this stops, then turn the knob slowly to open the fuel fill cap.
.png)
5. Place the fuel fill cap in the holder.
6. Insert the filler nozzle fully.
- When the tank is full, the fuel nozzle will click off automatically. This leaves space in the fuel tank in case the fuel expands with a change in the temperature.
7. After filling, replace the fuel fill cap, tightening it until you hear it click at least once.
- Shut the fuel fill door by hand.
.png)
WARNING
Gasoline is highly flammable and explosive.
You can be burned or seriously injured when handling fuel.
- Stop the engine, and keep heat, sparks, and flame away.
- Handle fuel only outdoors.
- Wipe up spills immediately.
The filler nozzle automatically stops to leave space in the fuel tank so that fuel does not overflow as a result of changes in air temperature.
If the filler nozzle keeps turning off when the tank is not full, there may be a problem with the pump's fuel vapor recovery system. Try filling at another pump. If this does not fix the problem, consult a dealer.
Do not continue to add fuel after the nozzle has automatically stopped. Additional fuel can exceed the full tank capacity.
READ NEXT:
Fuel Economy
Improving Fuel Economy
Fuel economy depends on several conditions, including driving conditions,
your
driving habits, the condition of your vehicle, and loading. Depending on these
and
other conditi
Accessories and Modifications
Accessories
When installing accessories, check the following:
Do not install accessories on the windshield. They can obstruct your
view and
delay your reaction to driving conditions.
Do not inst
SEE MORE:
Driving Preparation
Check the following items before you start driving.
■Exterior Checks
Make sure there are no obstructions on the windows, door mirrors,
exterior
lights, or other parts of the vehicle.
Remove any frost, snow, or ice.
Remove any snow on the roof, as this can slip down and obstruct your
fi
VSA DTC Troubleshooting 151-31: TPMS Switch Circuit Open
NOTE:
Pressing and holding the TPMS switch for more than 60 seconds will cause
this DTC to set.
Before you troubleshoot, review the general troubleshooting information.
1. Problem verification:
Turn the vehicle to the ON mode.
Clear the DTC with the HDS.
Turn the vehicle to the OFF (LOCK)
