Honda HR-V: Inspection/Adjustment
Honda HR-V (2015-2021) Service Manual / Brakes / Brake System - Overhaul, Testing & Troubleshooting / Inspection/Adjustment
- Brake Hose and Line Inspection
- Brake Pedal and Brake Pedal Position Switch Adjustment
- Front Brake Disc Inspection
- Rear Brake Disc Inspection
READ NEXT:
Brake Hose and Line Inspection
Inspection
1. Brake Hose and Line - Inspect
Check the brake lines for damage, rusting, and leaks. Also check for
bent brake lines
Check for leaks at hose and line joints and connections, and reti
Brake Pedal and Brake Pedal Position Switch Adjustment
Adjustment
1. Steering Joint Cover - Remove
2. Driver's Side Front Door Sill Trim - Remove - Refer to: Interior Trim
Removal and Installation - Door
Areas, or Interior Trim Removal and Installation -
Front Brake Disc Inspection
Front Brake Disc Inspection
Inspection
1. Vehicle - Lift
2. Front Wheels - Remove
3. Brake Pad - Remove
4. Brake Disc Thickness and Parallelism - Inspect
Using a micrometer (A), measure the brake d
SEE MORE:
CVT Differential Carrier Bearing Outer Race Replacement (CVT)
Special Tools Required
Bearing Driver Attachment, 62 x 68 mm
07746-0010500
Driver Handle, 15 x 135L 07749-0010000
Bearing Driver Attachment, 62 x 64 mm
07947-6340400
Replacement
NOTE:
The carrier bearing and the carrier bearing outer race should be
replaced as a set.
Adjust the carrier
DTC Troubleshooting B00DF-13: Open in the Front Passenger's Airbag ON/OFF
Switch
NOTE:
Before doing this troubleshooting procedure, find out if the vehicle was
in a collision. If so, verify
that all the required components were replaced with new components of the
correct part number,
and that they were properly installed.
Before doing this troubleshooting procedure, rev
© 2019-2026 Copyright www.hohrv2.com
