Honda HR-V: Security System Keyless Entry System - Service Information
Honda HR-V (2015-2021) Service Manual / Accessories & Equipment / Security System Keyless Entry System - Service Information
- Immobilizer-Keyless Control Unit Removal and Installation
- Keyless Access Control Unit Removal and Installation
- Keyless Access Remote Removal, Installation, and Test
- Keyless Entry Transmitter Removal, Installation, and Test
- Security Horn Removal, Installation, and Test
READ NEXT:
Immobilizer-Keyless Control Unit Removal and Installation
Removal & Installation
NOTE:
SRS components are located in this area. Review the SRS component
locations - Refer to: SRS
Component Location Index (KA/KC), or SRS Component Location Index (KA/
Keyless Access Control Unit Removal and Installation
Removal & Installation
NOTE: If the keyless access control unit is replaced, do the keyless access
registration. If the original keyless
access control unit is installed, confirm that all systems
Keyless Access Remote Removal, Installation, and Test
Special Tools Required
Keyless Entry
Checker 07MAJSP00400
Test
NOTE:
If the doors do not lock or unlock with the remote, check the LED on the
remote by pressing the lock or
unlock button. If the
SEE MORE:
DTC U0100, U0122, U0128, U0131, U0151 (Gauge Control Module)
NOTE:
Refer to the DTC code shown on the display, and then inspect the
connectors and terminals based on the
instructions in the table below.
The DTC may be stored due to the grounding failure or the power source
failure at the transmitting
control unit (the grounding inspection and the pow
DTC C1873-00 (16-04): Steering Angle Sensor Malfunction (AWD)
NOTE: Before you troubleshoot, review the General Troubleshooting Information
for the AWD with
intelligent control system.
1. Problem verification:
Turn the vehicle to the ON mode.
Clear the DTC with the HDS.
Start the engine.
Check for DTCs with the HDS.
Is DTC C1873-00 indicated?
YES
The
© 2019-2026 Copyright www.hohrv2.com
