Honda HR-V: Symptom Troubleshooting
READ NEXT:
1. Gauge control module operation check.
Do the gauge control module self-diagnostic function.
Is the gauge control module OK?
YES
Go to step 2.
NO
Replace the gauge control module.
2. Open wire ch
1. DTC check.
Turn the vehicle to the ON mode.
Check for DTCs with the HDS.
Are there DTCs indicated?
YES
Go to indicated DTC's troubleshooting.
NO
Go to step 2.
2. Gauge control module operation
1. Problem verification.
Start the engine.
Check the electric parking brake system indicator.
Does the electric parking brake system indicator come on, then go off?
YES
Intermittent failure, the s
SEE MORE:
Removal
NOTE:
Use fender covers to avoid damaging painted surfaces.
To avoid damaging the wiring and terminals, unplug the wiring connectors
carefully while holding the
connector portion.
Connect the HDS to the DLC, and monitor ECT SENSOR 1. To avoid damaging
the cylinder head,
wait until
Removal
1. Vehicle - Lift
2. Rear Wheel - Remove
3. Rear Spindle Nut - Remove
Pry up the stake (A) on the spindle nut (B)
Remove the spindle nut.
4. Rear Differential - Remove
5. Rear Outboard Joint - Disconnect
Pull the knuckle outward, and separate the outboard joint from the
rear hub usi