Honda HR-V: VSA System - Service Information
Honda HR-V (2015-2021) Service Manual / Brakes / VSA System - Service Information
- Steering Angle Sensor Removal and Installation
- VSA Modulator-Control Unit Removal and Installation
- VSA OFF Switch Removal, Installation, and Test
- Wheel Speed Sensor Removal and Installation
READ NEXT:
Steering Angle Sensor Removal and Installation
Removal and Installation
NOTE: SRS components are located in this area. Review the SRS component
locations - Refer to: SRS
Component Location Index (KA/KC), or SRS Component Location Index (KA/KC), a
VSA Modulator-Control Unit Removal and Installation
Removal
Do not spill brake fluid on the vehicle; it may damage the paint. If brake
fluid gets on the paint, wash it off
immediately with water.
NOTE:
Be careful not to damage or deform the brake l
VSA OFF Switch Removal, Installation, and Test
Removal and Installation
1. Driver's Dashboard Lower Cover - Remove
2. VSA Off Switch - Remove
Square type
Circle type
3. All Removed Parts - Install
Install the parts in the reverse order of remo
SEE MORE:
AWD System Symptom Troubleshooting - AWD System Indicator Does Not
Come ON (AWD)
1. Problem verification.
Turn the vehicle to the ON mode.
Does the AWD system indicator come on?
YES
Intermittent failure, the system is OK at this time.
NO
The failure is duplicated. Go to step 2.
2. Gauge control module operation check.
Do the gauge control module self-diagnostic function.
D
Cylinder Head Assembly - Inspection & Adjustment
INSPECTION & ADJUSTMENT
CYLINDER HEAD INSPECTION FOR WARPAGE
Inspection
1. Cylinder Head - Remove
2. Cylinder Head Warpage - Inspect
Check the cylinder head for warpage. Measure along
the edges, and three ways across the center:
If warpage is less than 0.08 mm (0.0031 in)
cylinder head
© 2019-2026 Copyright www.hohrv2.com
