Honda HR-V: Adjusting the Sound
Press the
(sound) button, and
rotate
to scroll through the following choices:
.png)
.png)
.png)
Rotate
to adjust the sound
setting, then
press
.
The SVC has four modes: Off, Low, Mid, and High.
SVC adjusts the volume level based on the vehicle
speed. As you go faster, audio volume increases. As
you slow down, audio volume decreases.
Display Setup
You can change the brightness or color theme of the audio/information screen.
■Changing the Screen Brightness
.png)
1. Press the MENU/CLOCK button.
2. Rotate
to select Settings,
then press
.
3. Rotate
to select Display
Adjustment,
then press
.
4. Rotate
to select Brightness,
then press
.
5. Rotate
to adjust the setting,
then press
.
You can change the Contrast and Black level
settings in the same manner.
■Changing the Screen's Color Theme
.png)
1. Press the MENU/CLOCK button.
2. Rotate
to select Settings,
then press
.
3. Rotate
to select Color Theme,
then
press
.
4. Rotate
to select the setting
you want,
then press
.
READ NEXT:
The ST indicator appears on the display indicating
stereo FM broadcasts.
Stereo reproduction in AM is not available.
You can store 6 AM stations and 12 FM stations into
the preset memory.
Switchin
Your audio system supports audio CDs, CD-Rs, and CD-RWs in either MP3 or WMA,
or AAC*1 format. With the CD loaded, press the CD/AUX button.
*1:Only AAC format files recorded with iTunes are playable
Connect the iPod using your dock connector to the USB port, then press the
CD/
AUX button.
■How to Select a Song from the iPod Music List with the
Selector Knob
1. Press to display the iPod
musi
SEE MORE:
12 VOLT BATTERY SYMPTOM TROUBLESHOOTING - LOW OR DEAD 12 VOLT BATTERY
Low or Dead 12 Volt Battery
NOTE:
A 12 volt battery might be discharged under these conditions:
Driving a vehicle 6 miles (10 km) or less per day.
Leaving a vehicle idling with high electrical loads such as
headlight, sea
MTF INSPECTION AND REPLACEMENT (M/T)
Inspection
1. Vehicle - Lift
2. Engine Undercover - Remove
3. MTF - Check
Remove the oil check bolt (A) and the 6 mm sealing washer (B)
Check the condition of the MTF and make sure it is at the proper level
(C).NOTE: If the fluid is dirty, replace the MTF.