Honda HR-V: Cylinder Head Overhaul
Honda HR-V (2015-2021) Service Manual / General Information / Engine Overhaul Procedures / Cylinder Head Overhaul
- Cylinder Head Disassembly
- Valve Springs
- Valves & Valve Seats
- Cylinder Head Reassembly
- Rocker Arms & Assemblies
- Lifters
READ NEXT:
Cylinder Head Disassembly
NOTE: Examples used in this article are general in nature and do not
necessarily relate
to a specific engine or system. Illustrations and procedures have been chosen
to guide mechanic through engine
Valve Springs
NOTE: Examples used in this article are general in nature and do not
necessarily relate
to a specific engine or system. Illustrations and procedures have been chosen
to guide mechanic through engine
Valves & Valve Seats
NOTE: Examples used in this article are general in nature and do not
necessarily relate
to a specific engine or system. Illustrations and procedures have been chosen
to guide mechanic through engine
SEE MORE:
Advanced Diagnostics
DTC ADVANCED DIAGNOSTICS: SRS RELATED DTCS
NOTE
Always check "How to troubleshoot the SRS system" and proceed along each
"DTC Troubleshooting"
procedure.
Make sure the 12 volt battery is fully charged. If not, the results of
tests may not be accurate.
The SRS indicator will turn on when the
Keyless Buzzer Circuit Troubleshooting
Testing
1. Open wire check (GND line):
Turn the vehicle to the OFF (LOCK) mode.
Disconnect the following connector.
Keyless buzzer 3P connector
Check for continuity between test points 1 and 2.
Is there continuity?
YES
The GND wire is OK. Go to step 2.
NO
Repair an open or high resistance i
© 2019-2024 Copyright www.hohrv2.com
