Honda HR-V: General Information
Honda HR-V (2015-2021) Service Manual / General Information
- Information
- Danger/Warning/Caution Label Locations (KA/KC Models), Emergency Towing
- Lift and Support Points
- Parts Marking (KA/KC Models)
- A Few Words About Safety
- Lubricants and Fluids (KA/KC Models)
- Maintenance Minder General Information (KA/KC Models)
- Safety Messages
- Service Specifications
- Torque Specifications
- Anti-Lock Brake Safety Precautions
- ATEQ TPMS Reset Procedure
- BARTEC TPMS Reset Procedure
- Clutch Trouble Shooting
- Drive Axle Noise Diagnosis
- Electrostatic Discharge (ESD) Warning
- Emission Control Abbreviations (Gasoline & Diesel)
- Engine Overhaul Procedures
- Description, Engine Identification
- Inspection Procedures
- Cleaning Procedures
- Component Cleaning
- Cylinder Head Replacement
- Cylinder Head Overhaul
- Pistons, Connecting Rods & Bearings
- Crankshaft & Main Bearings
- Camshaft
- Timing Chains & Belts
- Timing Gears
- Oil Pump
- Break-in Procedure
- Engine Performance Diagnostic Routine Outline
- Engine Performance Safety Precautions
- English-Metric Conversion Chart
- Gear Tooth Contact Patterns
- General Cooling System Service
- Manual Transmission Trouble Shooting
- Parasitic Load Explanation & Test Procedures
- State Emission Standards
- Symptom Check List Worksheets
- Tire Pressure Monitor Systems
- Traction Control, 4WD, & AWD
- Trouble Shooting - Basic Procedures
- Accessories & Electrical
- Air Conditioning & Heat
- Brakes
- Engine Mechanical
- Engine Performance
- Manual Transmission
- Powertrain
- Steering & Suspension
- Trouble Shooting
- Waveforms - Injector Pattern Tutorial
- Purpose of this Article
- Is a Lab Scope Necessary?
- The Two Types of Injector Drivers
- Interpreting Injector Waveforms
- Current Waveform Samples
- Voltage Waveform Samples
- Wheel Alignment Theory & Operation
- Maintenance
- Reminder Indicator (Reset Procedures)
READ NEXT:
Danger/Warning/Caution Label Locations (KA/KC Models), Emergency Towing
DANGER/WARNING/CAUTION LABEL LOCATIONS (KA/KC MODELS)
Front Passenger's Compartment:
Steering Wheel:
Driver's Compartment:
Engine Compartment:
Driver's Doorjamb:
Passenger's Doorjamb:
EMERGENCY
Lift and Support Points
NOTE: If you are going to remove heavy components such as suspension
or the fuel tank from the rear of the vehicle, first support the front of the
vehicle with tall safety stands. When
substantial w
SEE MORE:
Rear Differential Breather Box and Hose Removal and Installation (AWD)
Removal & Installation
1. Vehicle - Lift
2. Rear Differential Breather Box and Hose - Remove
Rear differential pump motor
Rear differential
Disconnect the breather hoses
(A).
Remove the breather hoses (A)
Remove the breather box (B).
3. All Removed Parts - Install
Install the parts
Interpreting A Current Controlled Pattern
NOTE: Current controlled drivers are also known as "Peak and Hold"
drivers. They
typically require injector circuits with a total leg resistance with less than
12
ohm.
NOTE: This example is based on a constant power/switched ground circuit.
See Fig. 3 for pattern that the following text describe
© 2019-2026 Copyright www.hohrv2.com
