Honda HR-V: DTC 2610 DRAM Diag
NOTE:
- Check the vehicle 12 volt battery condition first.
- This navigation DTC sets when a problem with the internal DRAM is
detected (the DA Unit icon is red in
the System Links).
- Before you troubleshoot, make sure to follow the General Troubleshooting
Information.
- Check any official Honda service website for more service information
about the navigation system.
1. Problem verification:
- Clear the hard error codes.
- Turn the vehicle to the OFF (LOCK) mode then the ON mode.
- Check for hard error codes.
Is DTC 2610 indicated?
YES
Replace the audio-navigation unit.
NO
Intermittent failure, the system is OK at this time.
DTC 2610 DRAM DIAG
NOTE:
- Check the vehicle 12 volt battery condition first.
- This audio DTC sets when a problem with the audio unit internal DRAM is
detected (the DA Unit icon is
red in the System Links).
- Before you troubleshoot, make sure to follow the General Troubleshooting
Information.
1. Problem verification:
- Clear the hard error codes.
- Turn the vehicle to the OFF (LOCK) mode then the ON mode.
- Go into the System Diagnostic Mode, and select the DA UNIT icon from the
System Links - Refer to: Audio System Sound Quality Diagnosis, or Audio
System Diagnostic Mode (Without Navigation, Display Audio Type (7-inch
Screen), or Audio System Diagnostic Mode (Without Navigation, Color Audio
Type (5-inch Screen).
Is D-RAM OK indicated?
YES
Intermittent failure, the system is OK at this time.
NO
Replace the audio unit - Refer to: Audio Unit Removal and Installation
(Display Audio Type (7-inch Screen), or Audio Unit Removal and Installation
(Color Audio Type (5-inch Screen).
READ NEXT:
NOTE:
Check the vehicle 12 volt battery condition first.
This audio DTC sets when Connection NG is indicated in the LaneWatch
diagnosis (the LaneWatch icon
is red in the System Links).
Before y
NOTE:
Check the vehicle 12 volt battery condition first.
This navigation DTC sets when a problem is detected in the GPS antenna
(the GPS antenna icon is red in
the System Links).
Before you tro
NOTE:
Check the vehicle 12 volt battery condition first.
This audio DTC sets when a problem is detected in the internal GPS
receiver.
Before you troubleshoot, make sure to follow the General Tro
SEE MORE:
These screens allow you to troubleshoot the audio function.
ANC Check (Not supported)
Speaker Check (B)
Speaker Check
NOTE:
Make sure the audio system is off before this diagnosis.
While doing the diagnosis, the fader and the balance positions are set
to the center.
This diagnosis checks
DTC (Front Seat Heater Control Unit)
NOTE :
If you are troubleshooting multiple DTCs, be sure to follow the
instructions in B-CAN System Diagnosis
Test Mode A - Refer to: Body Electrical Troubleshooting - B-CAN System
Diagnosis Test Mode A -
Initial Communication and DTC Checks.
The seat h