Honda HR-V: DTC 2701 GPS Diag: Antenna
NOTE:
- Check the vehicle 12 volt battery condition first.
- This navigation DTC sets when a problem is detected in the GPS antenna
(the GPS antenna icon is red in
the System Links).
- Before you troubleshoot, make sure to follow the General Troubleshooting
Information.
- Check any official Honda service website for more service information
about the navigation system.
1. Problem verification:
- Clear the hard error codes.
- Turn the vehicle to the OFF (LOCK) mode then the ON mode.
- Check for hard error codes.
Is DTC 2701 indicated?
YES
The failure is duplicated, go to step 2.
NO
Intermittent failure, the system is OK at this time.
2. DTC check:
Check for hard error codes.
Is DTC 1301 indicated?
YES
Go to DTC 1301 troubleshooting.
NO
Replace the audio-navigation unit.
DTC 2701 GPS DIAG: ANTENNA
NOTE:
- Check the vehicle 12 volt battery condition first.
- This audio DTC sets when a problem is detected in the GPS antenna (the
GPS antenna icon is red in the
System Links).
- Before you troubleshoot, make sure to follow the General Troubleshooting
Information.
1. Problem verification:
- Clear the hard error codes.
- Turn the vehicle to the OFF (LOCK) mode then the ON mode.
- Check for hard error codes.
Is DTC 2701 indicated?
YES
The failure is duplicated, go to step 2.
NO
Intermittent failure, the system is OK at this time.
2. DTC check:
Check for hard error codes.
Is DTC 1301 indicated?
YES
Go to DTC 1301 troubleshooting.
NO
Replace the audio unit - Refer to: Audio Unit Removal and Installation
(Display Audio Type (7-inch Screen), or Audio Unit Removal and Installation
(Color Audio Type (5-inch Screen).
READ NEXT:
NOTE:
Check the vehicle 12 volt battery condition first.
This audio DTC sets when a problem is detected in the internal GPS
receiver.
Before you troubleshoot, make sure to follow the General Tro
NOTE:
Check the vehicle 12 volt battery condition first.
This audio DTC sets when Connection NG is indicated in the Aircon
diagnosis (the A/C icon is red in the
System Links).
Check for B-CAN D
REMOVAL & INSTALLATION
CRUISE CONTROL COMBINATION SWITCH REMOVAL, INSTALLATION, AND TEST
Removal and Installation
SRS components are located in this area. Review the SRS component locations -
Ref
SEE MORE:
DTC (Gauge Control Module)
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the
instructions in B-CAN System Diagnosis
Test Mode A - Refer to: Body Electrical Troubleshooting - B-CAN System
Diagnosis Test Mode A -
Initial Communication and DTC Checks.
If you have any loss
Overview
The electronic throttle control system (ETCS) opens and closes the throttle
valve by electronic control. This
system consists of a throttle actuator built into the throttle body, throttle
valve and throttle position (TP) sensor
A/B, accelerator pedal position (APP) sensor A/B, ETCS driver