Honda HR-V Owners & Service Manuals

Honda HR-V: DTC U0029 (Gauge Control Module) : F-CAN Communication Line Error

Honda HR-V (2015-2021) Service Manual / Accessories & Equipment / Gauge Control System - Diagnostics / DTC U0029 (Gauge Control Module) : F-CAN Communication Line Error

Gauge Control System - Diagnostics

DTC (Gauge Control Module)

NOTE:

  • If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A - Refer to: Body Electrical Troubleshooting - B-CAN System Diagnosis Test Mode A - Initial Communication and DTC Checks.
  • If you have any loss of communication DTCs for the PCM, troubleshoot those DTCs first.

1. Problem verification.

  1. Clear the DTCs with the HDS.

Clear DTCs

  1. Turn the vehicle to the OFF (LOCK) mode and then the ON mode.
  2. Wait for at least 6 seconds.
  3. Check for DTCs with the HDS.

Gauge Control System - Diagnostics

Is DTC U0029 indicated?

YES

Go to DLC Circuit Troubleshooting.

NO

Intermittent failure, the system is OK at this time.

    READ NEXT:

     DTC U0100, U0122, U0128, U0131, U0151 (Gauge Control Module)

    NOTE: Refer to the DTC code shown on the display, and then inspect the connectors and terminals based on the instructions in the table below. The DTC may be stored due to the grounding failure o

     DTC U1280 (Gauge Control Module) Communication Bus Line Error (BUS-OFF)

    DTC (Gauge Control Module) NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A - Refer to: Body Electrical Troubleshooting -

     DTC U1281 (Gauge Control Module) Lost Communication With MICU (MICU Frame)

    NOTE: Refer to the DTC code shown on the display, and then inspect the connectors and terminals based on the instructions in the table below. The DTC may be stored due to the grounding failure o

    SEE MORE:

     DTC U3000-51 (Gauge Control Module) Reprogramming Error

    DTC (Gauge Control Module) NOTE: Before update the gauge control module, make sure the 12 volt battery in the vehicle is fully charged, and connect a 12 volt jumper battery (not a battery charger) to maintain system voltage. Never turn the vehicle to the ACCESSORY mode or OFF (LOCK) mode, d

     PCM Idle Learn Procedure

    Procedure The idle learn procedure must be done so the PCM can learn the engine idle characteristics. Do the idle learn procedure whenever you do any of these actions: Replace the PCM. Reset the PCM. Update the PCM. Replace or clean the throttle body. When the engine or transmission is disas

    © 2019-2026 Copyright www.hohrv2.com