Honda HR-V: DTC U0402-68 TCM Malfunction
NOTE : Before you troubleshoot, review the how to troubleshoot information -
Refer to: How to Troubleshoot
the Forward Collision Warning (FCW), or How to Troubleshoot the Lane Departure
Warning (LDW).
.png)
DTCs (FCW/LDW)
1. Problem verification.
- Turn the vehicle to the ON mode.
- Clear the DTC with the HDS.
Clear DTCs
- Turn the vehicle to the OFF (LOCK) mode.
- Wait for 10 seconds.
- Turn the vehicle to the ON mode.
- Check for DTCs with the HDS.
.png)
Is DTC U0402-68 indicated?
YES
Go to PGM-FI system troubleshooting - Refer to: How to Troubleshoot the Fuel
and Emissions
Systems, or How to Troubleshoot the CVT System (CVT).
NO
Intermittent failure, the system is OK at this time.
DTC U0416-68 VSA SYSTEM MALFUNCTION
NOTE : Before you troubleshoot, review the how to troubleshoot information -
Refer to: How to Troubleshoot
the Forward Collision Warning (FCW), or How to Troubleshoot the Lane Departure
Warning (LDW).
.png)
DTCs (FCW/LDW)
1. Problem verification.
- Turn the vehicle to the ON mode.
- Clear the DTC with the HDS.
Clear DTCs
- Turn the vehicle to the OFF (LOCK) mode.
- Wait for 10 seconds.
- Turn the vehicle to the ON mode.
- Check for DTCs with the HDS.
.png)
Is DTC U0416-68 indicated?
YES
Go to VSA system troubleshooting.
NO
Intermittent failure, the system is OK at this time.
READ NEXT:
NOTE : Before you troubleshoot, review the how to troubleshoot information -
Refer to: How to Troubleshoot
the Forward Collision Warning (FCW), or How to Troubleshoot the Lane Departure
Warning (LDW
NOTE : Before you troubleshoot, review the how to troubleshoot information -
Refer to: How to Troubleshoot
the Forward Collision Warning (FCW), or How to Troubleshoot the Lane Departure
Warning (LDW
SEE MORE:
Removal & Installation
NOTE:
Keep grease away from the brake disc and the brake pads.
Unless otherwise indicated, illustrations used in the procedure are for
2WD model.
1. Vehicle - Lift
2. Rear Wheel - Remove
3. Parking Brake - Release
4. Rear Brake Pad - Remove
5. Brake Caliper Bracket -
TESTING
ENGINE START/STOP SWITCH TEST
Test
1. Dashboard switch Panel - Remove
2. Engine Start/Stop Switch - Test
Check the engine start/stop switch (A) according to the table.
NOTE:
When an LED is located between terminals, check if the LED
lights by connecting power and ground to the LE