Honda HR-V: Front Bumper
FRONT BUMPER DISASSEMBLY AND REASSEMBLY
Removal & Installation
1. Front Bumper - Remove
2. Front Grille - Remove
3. Front Bumper Lower Grille - Remove
4. Front Fog Light Trim - Remove
5. Front Bumper Air Spoiler - Remove
6. Front Lower Bumper - Remove
.png)
7. All Removed Parts - Install
- Install the parts in the reverse order of removal.
HORNS ELECTRONIC WIRING DIAGRAM
Refer to: Horn Wiring Diagram
REAR BUMPER DISASSEMBLY AND REASSEMBLY
Removal & Installation
1. Rear Bumper - Remove
2. Rear Corner Bumper - Remove
.png)
3. All Removed Parts - Install
- Install the parts in the reverse order of removal.
WIPER/WASHER (REAR WINDOW) ELECTRONIC WIRING DIAGRAM
Refer to: Wiper/Washer
WIPER/WASHER (WINDSHIELD) ELECTRONIC WIRING DIAGRAM
Refer to: Wiper/Washer
COMPONENT LOCATION INDEX
BUMPERS COMPONENT LOCATION INDEX
.png)
.png)
EXTERIOR TRIM COMPONENT LOCATION INDEX
.png)
.png)
FENDERWELL COMPONENT LOCATION INDEX
.png)
.png)
FUEL FILL DOOR MECHANICAL COMPONENT LOCATION INDEX
.png)
HEATED WINDSHIELD WIPER AREA COMPONENT LOCATION INDEX
.png)
.png)
HOOD COMPONENT LOCATION INDEX
.png)
HORNS COMPONENT LOCATION INDEX
.png)
TAILGATE COMPONENT LOCATION INDEX
.png)
WIPERS/WASHERS COMPONENT LOCATION INDEX
.png)
.png)
.png)
.png)
READ NEXT:
Interior Trim
CENTER CONSOLE DISASSEMBLY AND REASSEMBLY
Disassembly and Reassembly
1. Center Console - Remove
2. Center Console Cup Holder - Remove
Remove the screws, then remove the center console cup holder (A
Carpet Removal and Installation
Removal & Installation
NOTE : SRS components are located in this area. Review the SRS component
locations - Refer to: SRS
Component Location Index (KA/KC), or SRS Component Location Index (KA/KC)
SEE MORE:
ECON Switch Test
Test
1. Driver's Dashboard Lower Cover - Remove
2. ECON Switch - Test
Check the ECON switch (A) according to the table.
NOTE:
When an LED is located between terminals, check if the LED
illuminates by connecting power and ground to the LED.
Note this important operating characteristic; diode
No Sound Is Heard From The Speaker(s) (Display Is Normal) (Without
Navigation, Display Audio Type (7-inch Screen) )
NOTE:
Check the vehicle 12 volt battery condition first.
Set the fader and the balance positions to the center.
Before doing this troubleshooting, go to Audio unit power switch will
not turn on (No information display and no sound) (Without Navigation,
Display Audio Type (7-
inch Screen) ).
