Honda HR-V Owners & Service Manuals

Honda HR-V: HVAC System - Diagnostics

Honda HR-V (2015-2021) Service Manual / HVAC / HVAC System - Diagnostics

DTC TROUBLESHOOTING

DTC INDICATOR 2 : HVAC CONTROL UNIT INTERNAL ERROR

1. Problem verification:

  1. Clear the history DTCs.
  2. Do the Self-Diagnostic Function.
  3. Checking for DTCs.

Does the RECIRCULATION indicator blink twice?

YES

Replace the HVAC control unit.

NO

Intermittent failure, the system is OK at this time.

DTC INDICATOR 3 A PROBLEM IN THE RECIRCULATION CONTROL MOTOR CIRCUIT, LINKAGE, DOOR, OR MOTOR

1. Problem verification:

  1. Clear the history DTCs.
  2. Do the Self-Diagnostic Function.
  3. Checking for DTCs.

Does the RECIRCULATION indicator blink twice?

YES

Replace the HVAC control unit.

NO

Intermittent failure, the system is OK at this time.

DTC INDICATOR 3 A PROBLEM IN THE RECIRCULATION CONTROL MOTOR CIRCUIT, LINKAGE, DOOR, OR MOTOR

1. Problem verification:

  1. Clear the history DTCs.
  2. Do the Self-Diagnostic Function.
  3. Checking for DTCs.

Does the RECIRCULATION indicator blink three times?

YES

Go to step 2.

NO

Intermittent failure. Check for loose wires or poor connections on the recirculation control motor circuit.

2. Open wire check (F/R MTR(REC)/M-REC line):

  1. Turn the vehicle to the OFF (LOCK) mode.

    READ NEXT:

     HVAC System - Testing & Troubleshooting

     Inspection & Adjustment

    A/C SYSTEM CONTAMINATION INSPECTION Inspection NOTE: If the A/C compressor failure is diagnosed, always use this inspection to check the extent of contamination in the A/C system. The parts illu

     Description

    SEE MORE:

     Cylinder Bore Honing

    Honing 1. Oil Jet - Remove 2. Cylinder Bore - Honing Measure the cylinder bores. If the engine block is to be reused, hone the cylinders and remeasure the bores. Only scored or scratched cylinder bore must be honed. Hone the cylinder bores with honing oil and a fine (400 grit) stone. Honi

     Steering Tie-Rod End Ball Joint Boot Replacement

    Special Tools Required Ball Joint Remover, 28 mm 07MAC-SL00202 Ball Joint Thread Protector, 12 mm 07AAFSDAA100 Fork Seal Driver Weight 07747-0010100 Fork Seal Driver Attachment, 31.2 mm 07747-0010400 Replacement 1. Vehicle - Lift 2. Front Wheels - Remove 3. Tie-Rod End Ball Joint - Disconnect

    © 2019-2026 Copyright www.hohrv2.com