Honda HR-V: HVAC
- HVAC System - Service Information
- A/C Compressor Relief Valve Removal and Installation
- A/C Compressor Removal and Installation
- A/C Condenser Removal and Installation
- A/C Line Removal and Installation
- A/C Refrigerant Oil Replacement
- A/C Refrigerant Recovery/Evacuation/Charging
- Air Mix Control Motor/Mode Control Motor/Recirculation Control Motor Removal and Installation
- Blower Motor Removal and Installation
- Climate Control Unit Removal and Installation
- Evaporator Core Removal and Installation
- HVAC Unit Removal and Installation
- Heater Control Panel Removal and Installation
- Outside Air Temperature Sensor Removal, Installation, and Test
- HVAC System - Diagnostics
- HVAC System - Testing & Troubleshooting
READ NEXT:
A/C Compressor Relief Valve Removal and Installation
Removal & Installation
NOTE: If the A/C compressor relief valve released refrigerant to the
atmosphere, determine and correct the
cause of the excessive system pressure, then replace the relief v
A/C Compressor Removal and Installation
Removal & Installation
NOTE:
Do not install the A/C compressor into a system unless you are
completely sure that the system is free of
contamination. Installing the A/C compressor into a cont
SEE MORE:
Ball Joint Boot Replacement and Inspection
Special Tools Required
Bearing Driver Attachment, 40 mm
07GAF-SE00200
Inspection
1. Ball Joint Boot - Inspect
Check the ball joint boot for weakness, damage, cracks, and grease
leaks.
NOTE:
If the ball joint boot is damaged with grease leaks, replace the
appropriate part as an
assembly.
F-CAN Circuit Troubleshooting
1. F-CAN circuit resistance check:
Turn the vehicle to the OFF (LOCK) mode.
Jump the SCS line with the HDS.
SCS Short
Disconnect the following connector.
PCM connector A (51P)
Measure the resistance between test points 1 and 2.
Is there about 78-95 --
YES
Go to step 14.
NO
Go to step 2.
© 2019-2026 Copyright www.hohrv2.com
