Honda HR-V: Inspection/Adjustment
Honda HR-V (2015-2021) Service Manual / Engine / Engine Control System & Engine Mechanical - Testing & Troubleshooting / Inspection/Adjustment
- APP Sensor Signal Inspection
- Breather Line and Suction Line Inspection (2WD: KA/KC)
- Breather Line and Suction Line Inspection (AWD: KA/KC)
- Camshaft Inspection
- Catalytic Converter Inspection (KA/KC)
- Cylinder Bore Honing
- Idle Speed Inspection
- Valve Clearance Adjustment
- Valve Seat Reconditioning
READ NEXT:
APP Sensor Signal Inspection
Inspection
NOTE:
This procedure checks the APP sensor in its fully closed position. In
any other position, the APP sensor
stores DTCs which are covered in other troubleshooting procedures.
Check
Breather Line and Suction Line Inspection (2WD: KA/KC)
Special Tools Required
Fuel Pressure
Gauge
Attachment Set
07AAJ-S6MA150
Vacuum
Pump/Gauge,
0-30 inHg Snapon
YA4000A or
equivalent,
commercially
available
Inspection
1. Center Console - Remove
2. Shi
Breather Line and Suction Line Inspection (AWD: KA/KC)
Special Tools Required
Fuel Pressure
Gauge
Attachment Set
07AAJ-S6MA150
Vacuum
Pump/Gauge,
0-30 inHg Snapon
YA4000A or
equivalent,
commercially
available
Inspection
1. Front seat (driver's side) - R
SEE MORE:
Rear Door Glass Outer Weatherstrip Removal and Installation
Removal & Installation
1. Rear Door Panel - Remove
2. Rear Door Outer Handle - Remove
3. Rear Door Plastic Cover - Remove
Remove the plug caps (A)
Remove the rear door plastic cover (B) as needed.
NOTE : If the plastic
cover is damaged or torn, replace it with a new one.
4. Rear Door Glas
Steering Tie-Rod End Ball Joint Boot Replacement
Special Tools Required
Ball Joint
Remover, 28 mm
07MAC-SL00202
Ball Joint Thread
Protector, 12 mm
07AAFSDAA100
Fork Seal Driver
Weight
07747-0010100
Fork Seal Driver
Attachment, 31.2
mm
07747-0010400
Replacement
1. Vehicle - Lift
2. Front Wheels - Remove
3. Tie-Rod End Ball Joint - Disconnect
© 2019-2026 Copyright www.hohrv2.com
