Honda HR-V: Engine Control System & Engine Mechanical - Testing & Troubleshooting
Honda HR-V (2015-2021) Service Manual / Engine / Engine Control System & Engine Mechanical - Testing & Troubleshooting
- Inspection/Adjustment
- Description
- Testing
- General Information
- Symptom Troubleshooting
- Troubleshooting
- Wiring Diagram
- Component Location Index
- How to Information
READ NEXT:
APP Sensor Signal Inspection
Inspection
NOTE:
This procedure checks the APP sensor in its fully closed position. In
any other position, the APP sensor
stores DTCs which are covered in other troubleshooting procedures.
Check
Breather Line and Suction Line Inspection (2WD: KA/KC)
Special Tools Required
Fuel Pressure
Gauge
Attachment Set
07AAJ-S6MA150
Vacuum
Pump/Gauge,
0-30 inHg Snapon
YA4000A or
equivalent,
commercially
available
Inspection
1. Center Console - Remove
2. Shi
SEE MORE:
DTC U1280 (Gauge Control Module) Communication Bus Line Error (BUS-OFF)
DTC (Gauge Control Module)
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the
instructions in B-CAN System Diagnosis Test Mode A - Refer to: Body
Electrical Troubleshooting - B-CAN System Diagnosis Test Mode A - Initial
Communication and DTC Checks.
If you have any loss
Maintenance Minder General Information (KA/KC Models)
Maintenance Minder
The Maintenance Minder is an important feature of the information display.
Based on engine and transmission operating conditions, and accumulated engine
revolutions, the HR-V's onboard
computer (PCM) calculates the remaining engine oil and the transmission fluid
life. The syste
© 2019-2026 Copyright www.hohrv2.com
