Honda HR-V: Lubrication System - Testing & Troubleshooting
Honda HR-V (2015-2021) Service Manual / Engine / Lubrication System - Testing & Troubleshooting
READ NEXT:
Description
ENGINE LUBRICATION SYSTEM DESCRIPTION - HYDRAULIC CIRCUIT
Overview
The lubrication method is a pressurized circulation type and it employs the
full-flow filtering system. In the
full-flow filtering s
Check
ENGINE OIL LEVEL CHECK
Check
1. Engine Oil Level - Check
Park the vehicle on level ground, and start the engine. Hold the engine
speed at 3,
000 RPM with no load (M/T in neutral, CVT in P or N)
Symptom Troubleshooting
ENGINE LUBRICATION SYSTEM SYMPTOM TROUBLESHOOTING - LOW OIL PRESSURE
INDICATOR DOES NOT COME ON WITH THE VEHICLE IN THE ON MODE
1. Input signal test:
Connect the HDS to the DLC.
Turn the vehicle to
SEE MORE:
DTC B1645, B1647, B1659, B1663 Antenna Circuit Short
NOTE: Refer to the DTC code shown on the display, and then inspect the
connectors and terminals based on
the instructions in the table below.
DTC (Keyless Access Control Unit)
NOTE: If you are troubleshooting multiple DTCs, be sure to follow the
instructions in B-CAN System
Diagnosis Test Mode A
Side Sill Panel Removal and Installation
Removal
1. Front Wheel Arch Protector - Remove - Refer to: Front Wheel Arch Protector
Removal and
Installation, or Rear Wheel Arch Protector Removal and Installation
2. Rear Wheel Arch Protector - Remove - Refer to: Front Wheel Arch Protector
Removal and
Installation, or Rear Wheel Arch Protector
© 2019-2026 Copyright www.hohrv2.com
