Honda HR-V: Occupant Detection System - Diagnostics
READ NEXT:
NOTE:
Before doing this troubleshooting procedure, find out if the vehicle was
in a collision. If so, verify that all the required components were replaced
with new
components of the correct p
NOTE:
Before doing this troubleshooting procedure, find out if the vehicle was
in a collision. If so, verify that all the required components were replaced
with new
components of the correct pa
SEE MORE:
When replacing, use the following bulbs.
High/Low beam headlight: 60/55 W (HB2 for halogen bulb type)
■High/Low Beam Headlight
1. Remove the coupler.
2. Remove the rubber weather seal.
3. Remove the hold-down wire, then remove
the bulb.
4. Insert a new bulb.
5. Reinstall the hold-down wire. Ho
COOLANT CHECK
Check
1. Coolant - Check
Check the coolant level in the coolant reservoir. Make sure it is
between the MAX
mark (A) and the MIN mark (B)
If the coolant level in the coolant reservoir is at or below the MIN
mark, add
coolant to bring it between the MIN and MAX marks, then insp