Honda HR-V: Seat Belts - Inspection & Adjustment
READ NEXT:
SEAT BELT INSPECTION
Inspection
1. Seat Belt - Inspect (In Vehicle)
In-Vehicle
Check that the seat belt is not twisted or caught on anything.
After installing the anchors, check for free movement o
SRS SYSTEM DESCRIPTION - SEAT BELT OUTER LAP TENSIONER
The seat belt outer lap tensioner is located on the side of the driver's
seat. In the event of a collision, the seat belt
outer lap tensioner co
SEE MORE:
Test
1. Front Passenger's Door Panel - Remove
2. Front Passenger's Power Window Motor - Test
Test the motor in each direction by connecting 12 volt battery power and
ground
to the connector (A) according to the table. When the motor stops running,
disconnect 12 volt battery power immediately
NOTE: Refer to the DTC code shown on the display, and then inspect the
connectors and terminals based on
the instructions in the table below.
DTC (Keyless Access Control Unit)
NOTE: If you are troubleshooting multiple DTCs, be sure to follow the
instructions in B-CAN System
Diagnosis Test Mode A