Honda HR-V: Supplemental Restraint System - Service Information
READ NEXT:
Removal
SRS components are located in this area. Review the SRS component locations -
Refer to: SRS Component
Location Index (KA/KC), or SRS Component Location Index (KA/KC) and the
precautions and
Removal and Installation
SRS components are located in this area. Review the SRS component locations -
Refer to: SRS Component
Location Index (KA/KC), or SRS Component Location Index (KA/KC) and the
Removal and Installation
SRS components are located in this area. Review the SRS component locations -
Refer to: SRS Component
Location Index (KA/KC), or SRS Component Location Index (KA/KC) and the
SEE MORE:
NOTE: Current controlled drivers are also known as "Peak and Hold"
drivers. They
typically require injector circuits with a total leg resistance with less than
12
ohm.
NOTE: This example is based on a constant power/switched ground circuit.
See Fig. 3 for pattern that the following text describe
Special Tools Required
Fuel Nut Wrench 07AAAT0AA100
Removal
1. Fuel Pressure - Relieve
2. Front Seat (Driver's Side) - Remove
3. Rear Heater Duct (Left Side) - Remove
4. Access Panel - Remove
Remove the access panel (A) from the floor
Disconnect the connector (B).
5. Fuel Tank Unit Locknut -