Honda HR-V: Testing
- Fuel Gauge Sending Unit Test (2WD)
- Fuel Gauge Sending Unit Test (AWD)
- Fuel Pressure Test
- Secondary Fuel Gauge Sending Unit Test (AWD)
READ NEXT:
Fuel Gauge Sending Unit Test (2WD)
Test
NOTE: Unless otherwise indicated, illustrations used in the procedure are for
USA and Canada models
1. Fuse - Check
Check the No. B21 (10 A) +B BACK UP fuse in the under-hood fuse/relay
box
Fuel Gauge Sending Unit Test (AWD)
Test
1. Fuse - Check
Check the No. B21 (10 A) +B BACK UP fuse in the under-hood fuse/relay
box and the No. C34
(7.5 A) IG1 METER fuse in the under-dash fuse/relay box before testing.
2. Body Ele
Fuel Pressure Test
Special Tools Required
Fuel Pressure
Gauge
07406-004000B
Fuel Pressure
Gauge
Attachment Set
07AAJ-S6MA150
Test
1. Fuel Pressure - Relieve
2. Fuel Pressure - Test
NOTE: If you were referred to this
SEE MORE:
AWD Control Unit Removal and Installation (AWD)
Removal
1. Rear Left Side Trim Panel - Remove - Refer to: Interior Trim
Removal and Installation - Rear Side
Area, or
2. AWD Control Unit - Remove
Turn the vehicle to the OFF (LOCK) mode
Loosen the AWD control unit mounting bolts (A), and remove the AWD
control unit (B)
Disconnect connector (
General Information
HOW TO ENTER VSA MAINTENANCE MODE
Procedure
1. Maintenance Mode - Enter
NOTE:
Entering condition of VSA Maintenance Mode - Refer to: VSA System
Description - Hill
Start Assist Control, or VSA System Description - System Diagram, or VSA
System
Description - Engine Drag Torque Control, or VSA
© 2019-2026 Copyright www.hohrv2.com
