Honda HR-V: Testing
- Door Key Cylinder Switch Test
- Door Lock Knob Switch Test
- Immobilizer System Status Log
- Keyless Access LF Antenna Function Test
- Keyless Access System Status Log
READ NEXT:
Door Key Cylinder Switch Test
Test
1. Driver's Door Panel - Remove
2. Driver's Door Key Cylinder Switch - Test
Disconnect the connector (A).
Check for continuity between the terminals in each
switch position according to the
Door Lock Knob Switch Test
Test
Driver's door
1. Driver's Door Panel - Remove
2. Driver's Door Lock Knob Switch - Test
Disconnect the connector (A).
Check for continuity between the terminals in each
switch position accor
Immobilizer System Status Log
If you suspect there is an immobilizer system problem, check the status log
in the HDS.
1. Connect the HDS to the data link connector (DLC).
2. Turn the vehicle to the ON mode.
3. On the HDS screen,
SEE MORE:
Throttle Body Removal and Installation
Removal
Do not insert your fingers into the installed throttle body when you turn the
vehicle to the ON mode, or while
the vehicle is in ON mode. If you do, you will seriously injure your fingers if
the throttle valve is activated.
NOTE: If you are replacing the throttle body, start at 1st proced
DTC Troubleshooting 26-120: Lateral Acceleration Sensor (Inside of
Modulator-Control Unit) Stuck
NOTE:
Before you troubleshoot, review the general troubleshooting information.
The yaw rate-acceleration sensor is built into the VSA modulator-control
unit.
Before troubleshooting, check the VSA modulator-control unit for proper
mounting. Improper mounting
of the VSA modulator-control unit
© 2019-2026 Copyright www.hohrv2.com
