Honda HR-V: "T", "V", "W"
"T"
TAA
Turbo Air-To-Air
TAA
Throttle Actuator Assembly
TAB
Thermactor Air By-Pass
TAD
Thermactor Air Diverter
TAC
Thermostatic Air Cleaner
TBI
Throttle Body Injection
TBPCS
Throttle By-Pass Control System
TC
Turbo Charger
TCC
Torque Converter Clutch
TCCL
Torque Converter Control
TCD
Throttle Closing Dashpot
TC-DV
TC Delay Valve
TC-TVC
TC Thermal Vacuum Switch
TC-VS
TC Vacuum Switch
TD
Thermactor Diverter
TFT
Tank Fuel Temperature Sensor
THOS2
Third Heated Oxygen Sensor
TICV
Thermal Ignition Control Valve
TIV
Thermal Idle Valve
TK
Throttle Kicker
TLUC
Transmission Lock-Up Converter
TLUC-TVS
TLUC Thermal Vacuum Switch
TLUC-VS
TLUC Vacuum Switch
TM
Throttle Modulator
TOS
Throttle Opener System
TP
Throttle Positioner
TPI
Tuned Port Fuel Injection
TPV
Throttle Poppet Valve
TR
Thermal Reactor
TRC
Throttle Return Control
TRCS
Throttle Return Control Solenoid
TRCTL
Throttle Return Control Throttle Lever Actuator
TRSCV
Throttle Return Solenoid Control Valve
TRTVV
Temperature Regulator Thermal Vacuum Valve
TRVV
Transmission Vacuum Valve
TSOL
Throttle Solenoid
TVISD
Throttle Vacuum Idle Speed Diaphragm
TVM
Transmission Vacuum Modulator
TVS
Thermal Vacuum Switch
TWC
Three-Way Catalytic Converter
TWC+OC
Three-Way + Oxidation Catalytic Converter
"V"
VA
Vacuum Advance Unit
VAC-AMP
Vacuum Amplifier
VA-CTO
VA Coolant Temperature Override
VC
Vapor Canister
VCV
Vacuum Cut Valve
VCV-BV
VCV By-Pass Valve
VLFR
Vent Line Flow Restrictor/Anti-Trickle Fill Valve
"W"
WU
Warm-Up Catalyst
WU-OC
Warm-Up Oxidation Converter
WU-TWC
Warm-Up Three-Way Catalytic Converter
READ NEXT:
Description, Engine Identification
DESCRIPTION
Examples used in this article are general in nature and do not necessarily
relate to a specific engine or system.
Illustrations and procedures have been chosen to guide mechanic through
Inspection Procedures
* PLEASE READ THIS FIRST *
NOTE: Examples used in this article are general in nature and do not
necessarily relate
to a specific engine or system. Illustrations and procedures have been chosen
to gui
SEE MORE:
Synchro Sleeve and Hub Disassembly, Reassembly, and Inspection (M/T)
Inspection
1. Synchro Sleeve and Hub - Inspect
Inspect the gear teeth on all synchro hubs and synchro sleeves for wear
(rounded off
corners)
Install each synchro hub (A) in its mating synchro sleeve (B), and check
for free
movement. Make sure to match the three sets of longer teeth (C) (12
Audio System Theft Protection
The audio system is disabled when it is disconnected from the power source,
such as
when the battery is disconnected or goes dead. In certain conditions, the system
may display ENTER CODE*2/Enter code*3. If this occurs, reactivate the audio
system.
■ Reactivating the audio system
1. Turn the igni
