Honda HR-V: VSA System - Testing & Troubleshooting
READ NEXT:
When wheel speed is significantly reduced from estimated vehicle speed, the
VSA modulator-control unit
closes the inlet valve and opens the outlet valve momentarily to reduce brake
fluid pressure an
Overview
The hill start assist control assists drivers by automatically controlling
brake pressure when starting a vehicle on
a steep hill; this assist prevents the vehicle from rolling on a hill for
SEE MORE:
NOTE : Refer to the DTC code shown on the display, and then inspect the
connectors and terminals based on
the instructions in the table below.
DTC (Front Seat Heater Control Unit)
NOTE :
If you are troubleshooting multiple DTCs, be sure to follow the
instructions in B-CAN System Diagnosis
Tes
Removal and Installation
1. 12 Volt Battery - Remove
2. Front Grille Cover - Remove
3. Air Intake Duct - Remove
4. Front Grille Center Stay - Remove
5. Hood Latch - Remove
NOTE:
Do not disconnect the hood opener cable.
Disconnect the connector at the same time.
6. Engine Undercover - Remove (Wit