Honda HR-V: BARTEC TPMS Reset Procedure
Models With Information Display
1. Inflate tires to correct pressure.
2. Apply parking brake.
3. Turn Ignition ON.
4. Press and hold the TPMS button. The MIL will flash.
5. Release parking brake.
6. Drive vehicle.
NOTE: If the MIL does not blink a few the relearn procedure did not take. Repeat procedure.
NOTE: The relearn process requires about 30 minutes of cumulative driving at speeds between 30-60 mph.
Model With Multi-Information Display
1. Inflate tires to correct pressure.
2. Apply parking brake.
3. Turn ignition ON.
4. Press and hold DISPLAY button.
5. Press the UP/DOWN arrow button to select VEHICLE SETTINGS, then press SEL/RESET button.
6. TPMS Calibration appears on display.
7. Press SEL/RESET button.
8. The display switches to the customization setup screen, where you can select CANCEL or CALIBRATE.
9. Press the UP/DOWN button, select CALIBRATE then press SEL/RESET button. The screen displays CALIBRATION STARTED.
10. Release parking brake.
11. Drive vehicle to complete procedure.
NOTE: The calibration process requires about 30 minutes of cumulative driving at speeds between 30-60 mph.
NOTE: Models with the smart entry system have an ENGINE START/STOP button instead of an ignition switch.
READ NEXT:
Clutch Trouble Shooting
* PLEASE READ THIS FIRST *
NOTE: This is GENERAL information. This article is not intended to be
specific to any
unique situation or individual vehicle configuration. For model-specific
information s
Drive Axle Noise Diagnosis
* PLEASE READ THIS FIRST *
NOTE: This is GENERAL information. This article is not intended to be
specific to any
unique situation or individual vehicle configuration. For model-specific
information s
Electrostatic Discharge (ESD) Warning
* PLEASE READ THIS FIRST *
NOTE: This article is intended for general information purposes only.
Contents are
generic in nature and all information may or may not apply to all vehicles.
INTRODUCTION
SEE MORE:
Engine Oil Replacement Reminder Reset - Procedure 9, 10, 11, 12, 13, 14, 15,
16, 17, 18, 19
ENGINE OIL REPLACEMENT REMINDER RESET - PROCEDURE 9
1. Turn the ignition switch to ON (II).
NOTE: If system messages are displayed, press the INFO button to cancel
the
display.
2. Push the ARROW buttons repeatedly until the engine oil life indicator is
displayed. See Fig. 7.
3. Select RESET with
DTC Troubleshooting 97-12: Automatic Brake Hold Switch Signal Circuit Short
NOTE: Before you troubleshoot, review the general troubleshooting
information.
1. Problem verification:
Turn the vehicle to the ON mode.
Clear the DTC with the HDS.
Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.
Check for DTCs with the HDS.
Is DTC 97-12 indicated?
YES
The fai
