Honda HR-V: Brake System - Service Information
READ NEXT:
Removal & Installation
1. Center Console Panel - Remove
2. Electric Parking Brake/Automatic Brake Hold Switch - Remove
Remove the electric parking brake/automatic brake hold
switch (A)
3. All
Removal & Installation
1. Air Cleaner - Remove
2. Master Cylinder - Remove
3. Brake Line - Remove
Remove the brake lines (A) from the brake line clamp
(B).
Remove the brake lines (A) from
Removal
Do not spill brake fluid on the vehicle; it may damage the paint. If brake
fluid gets on the paint, wash it off
immediately with water.
NOTE: After removal, plug the ends of the hoses and th
SEE MORE:
NOTE:
Before you troubleshoot, review the general troubleshooting information.
The yaw rate-acceleration sensor is built into the VSA modulator-control
unit.
Before troubleshooting, check the VSA modulator-control unit for proper
mounting. Improper mounting
of the VSA modulator-control unit
NOTE:
Check the vehicle 12 volt battery condition first.
This navigation DTC sets when a problem with the internal DRAM is
detected (the DA Unit icon is red in
the System Links).
Before you troubleshoot, make sure to follow the General Troubleshooting
Information.
Check any official Honda