Honda HR-V: Cylinder Head Assembly - Service Information
Honda HR-V (2015-2021) Service Manual / Engine / Cylinder Head Assembly - Service Information
READ NEXT:
Cylinder Head Cover Removal and Installation
Removal
1. Harness Cover - Remove
2. Positive Cable and Connector (Alternator) - Disconnect
NOTE: Remove the positive cable clamp at the same time.
3. Cylinder Head Cover Harness Holder - Move
Disc
Cylinder Head Removal and Installation
Removal
NOTE:
Use fender covers to avoid damaging painted surfaces.
To avoid damaging the wiring and terminals, unplug the wiring connectors
carefully while holding the
connector portion.
Conne
Cylinder Head Assembly - Inspection & Adjustment
INSPECTION & ADJUSTMENT
CYLINDER HEAD INSPECTION FOR WARPAGE
Inspection
1. Cylinder Head - Remove
2. Cylinder Head Warpage - Inspect
Check the cylinder head for warpage. Measure along
the edg
SEE MORE:
DTC 2618 LaneWatch Diag
NOTE:
Check the vehicle 12 volt battery condition first.
This audio DTC sets when Connection NG is indicated in the LaneWatch
diagnosis (the LaneWatch icon
is red in the System Links).
Before you troubleshoot, make sure to follow the General Troubleshooting
Information.
Check the connector
DTC Troubleshooting 12-12, 14-12, 16-12, 18-12: Wheel Speed Sensor Short to
the Other Sensor Circuit
NOTE:
Before you troubleshoot, review the general troubleshooting information.
These DTCs may be caused by electrical interference. Check for
aftermarket devices installed in the
vehicle when these DTCs are indicated.
1. Problem verification:
Turn the vehicle to the ON mode.
Clear the DTC
© 2019-2026 Copyright www.hohrv2.com
