Honda HR-V: DTC Troubleshooting 84-91: Front Passenger's Weight Sensor Not
Calibrated
NOTE:
- Before doing this troubleshooting procedure, find out if the vehicle was
in a collision. If so, verify that all the required components were replaced
with new
components of the correct part number, and that they were properly
installed.
- Before doing this troubleshooting procedure, review SRS Precautions and
Procedures and General Troubleshooting Information.
.png)
DTC (SWS)
1. Problem verification:
- Clear the DTCs with the HDS.
- Turn the vehicle to the ON mode, then wait for 10 seconds.
- Check for DTCs with the HDS.
.png)
Is DTC 84-91 indicated?
YES
The failure is duplicated. Do the front passenger's weight sensor unit
initialization.
NO
Intermittent failure, the system is OK at this time. Go to Troubleshooting
Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.
DTC TROUBLESHOOTING 84-93, 84-94, 84-95, 84-96: DIFFERENT SERIAL ID OF THE
FRONT PASSENGER'S WEIGHT SENSOR
NOTE:
- Before doing this troubleshooting procedure, find out if the vehicle was
in a collision. If so, verify that all the required components were replaced
with new
components of the correct part number, and that they were properly
installed.
- Before doing this troubleshooting procedure, review SRS Precautions and
Procedures and General Troubleshooting Information.
.png)
1. Problem verification:
- Clear the DTCs with the HDS.
- Turn the vehicle to the ON mode, then wait for 10 seconds.
- Check for DTCs with the HDS.
.png)
Is DTC 84-93, 84-94, 84-95, or 84-96 indicated?
YES
The failure is duplicated. Replace the front passenger's seat rail including
all four front passenger's weight sensors.
NO
Intermittent failure, the system is OK at this time. Go to Troubleshooting
Intermittent Failures. If another DTC is indicated, troubleshoot the DTC.
READ NEXT:
DTC ADVANCED DIAGNOSTICS SRS RELATED DTCS
NOTE
Always check "How to troubleshoot the SRS system" and proceed along each
"DTC Troubleshooting" procedure.
Make sure the 12 volt battery is fully cha
Removal and Installation
NOTE: SRS components are located in this area. Review the SRS component
locations - Refer to: SRS
Component Location Index (KA/KC), or SRS Component Location Index (KA/KC) an
SEE MORE:
Models with display audio system
To use the audio system function, the ignition switch must be in ACCESSORY
(I) or
ON (II)*1.
: Select to go to the HOME
screen.
: Touch to select any mode.
The available mode includes Change Source,
Station List, Save Preset, Radio Text,
Music Search, and play mod
Removal & Installation
NOTE:
Keep grease away from the brake disc and the brake pads.
Unless otherwise indicated, illustrations used in the procedure are for
2WD model.
1. Vehicle - Lift
2. Rear Wheel - Remove
3. Parking Brake - Release
4. Rear Brake Pad - Remove
5. Brake Caliper Bracket -