Honda HR-V: Seat Belts - Service Information
READ NEXT:
Removal and Installation
NOTE: SRS components are located in this area. Review the SRS component
locations - Refer to: SRS
Component Location Index (KA/KC), or SRS Component Location Index (KA/KC) an
Removal and Installation
NOTE: SRS components are located in this area. Review the SRS component
locations - Refer to: SRS
Component Location Index (KA/KC), or SRS Component Location Index (KA/KC) an
Removal and Installation
1. Rear Seat Belt Buckle - Remove
Release the elastic straps (A).
Fig. 8: Rear Seat Belt Buckle With Torque Specifications
Fold down both rear seat-back
Pull up the bo
SEE MORE:
Removal & Installation
A-Pillar Trim
1. A-Pillar Trim - Remove
Remove the front door opening seal (A) as needed
Remove the A-pillar trim (B).
2. All Removed Parts - Install
Install the parts reverse order of removal.
B-Pillar Upper/Lower Trim
3. Front Door Sill Trim - Remove - Refer to:
Special Tools Required
Attachment, 22 x 24 mm
07746-001A800
Driver Handle, 15 x 135L 07749-0010000
Replacement
NOTE: Apply a light coat of clean transmission fluid on all parts before
installation.
1. Control Shaft Oil Seal - Remove
2. Control Shaft Oil Seal - Install
Install the oil seal (A)