Honda HR-V: Electrical System - Service Information
Honda HR-V (2015-2021) Service Manual / Electrical / Electrical System - Service Information
- 12 Volt Battery Removal and Installation
- Auxiliary Under-Dash Fuse Box Removal and Installation
- Front Accessory Power Socket Removal and Installation
- Rear Accessory Power Socket Removal and Installation
- Under-Dash Fuse/Relay Box Removal and Installation
- Under-Dash Subrelay Box Removal, Installation, and Test
- Under-Hood Fuse/Relay Box Removal and Installation
READ NEXT:
12 Volt Battery Removal and Installation
Removal
1. 12 Volt Battery Terminal - Disconnect
2. 12 Volt Battery - Remove
Remove the 12 volt battery setting plate (A) and the 12 volt
battery (B).
Installation
1. 12 Volt Battery - Install
Auxiliary Under-Dash Fuse Box Removal and Installation
Removal & Installation
1. 12 Volt Battery Terminal - Disconnect
2. Auxiliary Under-Dash Fuse Box A - Remove
Remove the cover (B) from the auxiliary under-dash fuse
box A (A)
Remove the cable
Front Accessory Power Socket Removal and Installation
Removal & Installation
1. Front Accessory Power Socket - Remove
Gently press the tabs (A), and remove the front accessory
power socket (B).
Gently press the tabs (A), and remove the housin
SEE MORE:
AWD Control Unit Removal and Installation (AWD)
Removal
1. Rear Left Side Trim Panel - Remove - Refer to: Interior Trim
Removal and Installation - Rear Side
Area, or
2. AWD Control Unit - Remove
Turn the vehicle to the OFF (LOCK) mode
Loosen the AWD control unit mounting bolts (A), and remove the AWD
control unit (B)
Disconnect connector (
DTC B0029-12
NOTE:
Before doing this troubleshooting procedure, find out if the vehicle was
in a collision. If so, verify
that all the required components were replaced with new components of the
correct part number,
and that they were properly installed.
Before doing this troubleshooting procedure, rev
© 2019-2026 Copyright www.hohrv2.com
