Honda HR-V: Inputs and Outputs
Honda HR-V (2015-2021) Service Manual / Driveline & Axles / Differential - Testing & Troubleshooting / Inputs and Outputs
- AWD Control Unit Connector For Inputs And Outputs (AWD)
- Rear Differential Fluid Inspection And Replacement (AWD)
READ NEXT:
AWD Control Unit Connector For Inputs And Outputs (AWD)
AWD Control Unit Inputs and Outputs for 24P Connector (Connector
Disconnected)
AWD SYSTEM BLEEDING (AWD)
Procedure
NOTE: Whenever the rear differential assembly is disassembled, the AWD with
intel
Rear Differential Fluid Inspection And Replacement (AWD)
Inspection
1. Vehicle - Lift
2. Rear Differential Fluid - Check
Fig. 4: Differential Fluid Check With Filler Plug Torque Specifications
Use solvent and a brush to wash any oil and dirt off the oil
How to Information
HOW TO TROUBLESHOOT THE AWD SYSTEM (AWD)
AWD System Indicator
The AWD system indicator will come on under certain conditions even if the
AWD with intelligent control
system is working normally. Here
SEE MORE:
Wheel Speed Sensor Removal and Installation
Removal and Installation
Front
1. Vehicle - Lift
2. Front Wheels - Remove
3. Front Wheel Speed Sensor - Remove
Remove the grommet (A) from the body.
Disconnect the connector (B)
Remove the wire guide rubbers (C), the clip (D), and the bolt (E)
Remove the wheel speed sensor (F).
4. All Removed
Under-Hood Fuse/Relay Box Removal and Installation
Special Tools Required
Relay Puller 07AAC-000A2A1 or
07AAC-000A1A0
Removal & Installation
NOTE: The under-hood fuse/relay box is a part of the left engine compartment
wire harness, and it cannot be
replaced by itself.
1. 12 Volt Battery Terminal - Disconnect
2. PCM - Remove
3. Under-Hood Fuse/
© 2019-2026 Copyright www.hohrv2.com
