Honda HR-V: Inputs and Outputs
Honda HR-V (2015-2021) Service Manual / Accessories & Equipment / Seats - Testing & Troubleshooting / Inputs and Outputs
- Front Seat Heater Control Unit Connector For Inputs And Outputs
- Rear Seat Disassembly And Reassembly
- Rear Seat-Back Disassembly And Reassembly
READ NEXT:
Front Seat Heater Control Unit Connector For Inputs And Outputs
REAR SEAT CUSHION DISASSEMBLY AND REASSEMBLY
Disassembly & Reassembly
1. Rear Seat Cushion - Remove
2. Rear Seat Recline Cover - Remove
3. Rear Seat Hinge Cover -Remove
4. Rear Seat Cushion Pa
Rear Seat Disassembly And Reassembly
Disassembly & Reassembly
1. Rear Seat - Remove
2. Rear Seat - Disassemble
Remove the head restraint
Remove the recline upper cover (A).
NOTE : The illustration shows a left
rear seat. Do the
Rear Seat-Back Disassembly And Reassembly
Disassembly & Reassembly
1. Rear Seat-Back - Remove
2. Rear Seat-Back Latch - Remove
3. Rear Seat Armrest - Remove
4. Rear Seat-Back Pad/Frame - Remove
Remove the tether anchor cover (A) with a
SEE MORE:
DTC Troubleshooting B0091-87: No Signal From the Left Side Impact Sensor
(First)
NOTE:
Before doing this troubleshooting procedure, find out if the vehicle was
in a collision. If so, verify
that all the required components were replaced with new components of the
correct part number,
and that they were properly installed.
Before doing this troubleshooting procedure, rev
Under-Dash Fuse/Relay Box Removal and Installation
Special Tools Required
Relay Puller 07AAC-000A2A1 or
07AAC-000A1A0
Removal
NOTE:
SRS components are located in this area. Review the SRS component
locations - Refer to: SRS
Component Location Index (KA/KC), or SRS Component Location Index (KA/KC) and
the
precautions and procedures before do
© 2019-2025 Copyright www.hohrv2.com
