Honda HR-V: Inspection & Adjustment
Honda HR-V (2015-2021) Service Manual / Transmission / Continuously Variable Transmission (CVT) - Testing & Troubleshooting / Inspection & Adjustment
- CVT Differential Backlash Inspection (CVT)
- Final Drive Shaft Tapered Roller Bearing Preload Inspection (CVT)
- Forward Clutch Clearance Inspection (CVT)
- Input Shaft Thrust Clearance Adjustment (CVT)
- Shift Cable Adjustment (CVT)
- Transfer Assembly Inspection (CVT)
READ NEXT:
CVT Differential Backlash Inspection (CVT)
Inspection
1. Differential Backlash - Inspect
Install both axles into the differential, then place the axles on
V-blocks (A)
Check the backlash of the pinion gears (B) using a dial indicator (C)
Final Drive Shaft Tapered Roller Bearing Preload Inspection (CVT)
Special Tools Required
Preload Inspection Tool 070AJ-5T0A100
Driver Handle, 40 mm I.D. 07746-0030100
Inspection
NOTE:
If the transmission housing, the torque converter housing, the final
drive s
Forward Clutch Clearance Inspection (CVT)
Special Tools Required
Clutch Compressor Attachment 07ZAE-PRP0100
Clutch Compressor Attachment 64 mm 07ZAE-PRP0110
Inspection
1. Forward Clutch Clearance - Inspect
Secure the input shaft assembly
SEE MORE:
Washer Tube Removal and Installation
Removal & Installation
NOTE : SRS components are located in this area. Review the SRS component
locations - Refer to: SRS
Component Location Index (KA/KC), or SRS Component Location Index (KA/KC) and
the precautions
and procedures before doing repairs or service.
Front Side Washer Tube
1. Fron
EPS Motor & Control Unit - Service Information
REMOVAL & INSTALLATION
EPS MOTOR/CONTROL UNIT REMOVAL AND INSTALLATION
Removal
1. Steering Column/EPS Control Unit - Remove
2. EPS Motor/Control Unit - Remove
Disconnect the connector (A)
Remove the EPS motor/control unit (B).
Installation
1. EPS Motor/Control Unit - Install
Fig. 1: EPS Mo
© 2019-2026 Copyright www.hohrv2.com
